Author Topic: Kenmore (Fridgidaire) Front Load washer  (Read 2712 times)

Offline 8857mama

  • VIP Member
  • Member Since: Sep 2008
  • Posts: 1
Kenmore (Fridgidaire) Front Load washer
« on: September 24, 2008, 11:38:41 AM »
push start - motor runs for 5-10 seconds - shuts down - replaced control panel - new control panel came with notice that front loader don't need reed switch anymore - diagnostic code says magnet or reed switch - magnet is in place - why doesn't this junk run?

Model 417.44152400

Offline Repair-man

  • Technician
  • Member Since: Feb 2008
  • Posts: 3020
  • Country: us
  • The Virtual Repairman
    • The Virtual Repairmans Appliance Help
Re: Kenmore (Fridgidaire) Front Load washer
« Reply #1 on: September 24, 2008, 11:52:52 AM »
The motor speed control is likely bad, not the control panel. There's a tech sheet inside the lower panel which will guide you thru the diagnostics.
"It's only expensive if someone else fixes it for you" -
The Virtual Repairman   www.repair2000.com

 

Frigidiare Kenmore Front Load Washer Inner Tub & Tub Bearing Replacement.

Started by AJ

Replies: 5
Views: 7404
Last post March 03, 2008, 03:56:05 AM
by BrntToast
Kenmore front load tumble action washer

Started by MajorApp

Replies: 2
Views: 4049
Last post May 24, 2008, 10:51:35 AM
by MajorApp
Kenmore Frigidaire front load washer - No Spin

Started by jpn43

Replies: 8
Views: 6493
Last post September 01, 2009, 08:52:36 AM
by JWWebster
kenmore front load washer, soil selector touch button unresponsive

Started by helene

Replies: 1
Views: 1778
Last post September 07, 2009, 11:05:47 AM
by whirlpooltech
Kenmore Front Load Washer Won't Spin

Started by lilpig

Replies: 1
Views: 5295
Last post December 21, 2009, 11:39:04 AM
by Repair-man
kenmore front load washer

Started by daac

Replies: 3
Views: 2077
Last post March 01, 2010, 06:21:33 PM
by schaffersapplian