Forum Index > Refrigerator & Freezer Repair

How remove Kenmore ice/water dispenser housing ??


I need to replace water dispenser 'spout' - it has delivery tube attached.  Have removed front panel and housing screws - housing appears to be glued or taped - prying not very effective.  Is there a safe way to dislodge the housing from the door.  Kenmore side-by-side 106.595829902.
Thanks in advance for any advice offered.........

delivery tube?
Do you have a part number?

If this the tube that runs inside the freezer door?
If so the ones I have replaced all I did was remove the trim to get some extra room.
The tube should just pull in and out of the door.


[0] Message Index

Go to full version