UPDATE !!!! Problem Fixed !!!!
Since I all ready replaced the Thermistor, and Main PCB Board I thought I'd spend $2.36 cents for a new Sensor Bar. I order the (2) new sensor bars and they came in today. First off the Sensor Bars were not a direct replacement, they did not fit into the Sensor Bar Base - they were not shaped correctly and they sat about 1/4" taller in base (returning them) but after removing the original bars there was a large amount of Lint Build up under the sensors. So I removed both sensor bars and cleaned them with a High Pressure Air Compressor. Plugged the old bars back in and BINGO that fixed the problem. NO MORE SHORT CYCLING. I ran a test load of freshly washed shop towels and placed the Dryer in Sensor Dry on Heavy Duty and it ran perfectly!
Also be careful when replacing the PCB Board there is a Diagnostic Port that can be mistakenly used that the Thermistor harness fits perfectly in and that will give you a "TO" Error (Thermistor) if you plug the wrong harness connector in the Diagnostic Port. The Main PCB Board will not detect the Thermistor and throw a "TO Error Code"). Some times you learn by doing something STUPID but I'm glad STUPID Found the problem!!