Author Topic: Cool down cycle not cycling, Kenmore  (Read 1077 times)

Offline go2fast

  • VIP Member
  • Member Since: May 2014
  • Posts: 1
Cool down cycle not cycling, Kenmore
« on: May 06, 2014, 09:25:03 PM »
I have a Kenmore 110.69652800. Your basic old school dryer with an added moisture sensor and a small control board. On the auto/permanent press cycle, it no longer cycles the motor every couple of minutes during cool down. It does turn off the heat, but just keeps running to the end of the cycle.

If you turn the buzzer on, it will buzz every few minutes in the cool down cycle, but the motor just keeps running. So timer, control board, something else? Exactly what controls the motor cycling isn't clear to me.

Thanks for any tips!

Offline bagjr387

  • Technician
  • Member Since: Apr 2014
  • Posts: 47
Re: Cool down cycle not cycling, Kenmore
« Reply #1 on: May 07, 2014, 04:06:39 PM »
That sounds like the timer is shot...The buzzer gets voltage when cams on the timer allow it too. if its buzzing every few minutes, I would start there...Also if the timer is bad, it may keep running instead of stopping like you said
« Last Edit: May 07, 2014, 04:07:34 PM by bagjr387 »

 

Kenmore Electric Dryer - Quits in mid-cycle

Started by GaryGG

Replies: 5
Views: 5348
Last post February 15, 2008, 04:07:19 PM
by JWWebster
Kenmore Dryer Stops During a Cycle

Started by TechnicianBrian

Replies: 0
Views: 5934
Last post November 15, 2008, 08:27:31 AM
by TechnicianBrian
Kenmore dryer wont start/quits mid cycle

Started by Jwhite4095

Replies: 3
Views: 3986
Last post May 14, 2009, 07:43:00 AM
by Jwhite4095
Kenmore 90 Series dryer - used to stop mid-cycle, now won't start at all

Started by sguthrie04

Replies: 9
Views: 10308
Last post January 11, 2011, 07:54:32 AM
by sguthrie04
Kenmore 90 series dryer model 110.60901990 does not shut off in any cycle.

Started by dirtydog

Replies: 1
Views: 2068
Last post December 21, 2011, 09:17:44 AM
by bigbuck
Kenmore dryer cycling on & off

Started by kbrown5687

Replies: 4
Views: 1631
Last post May 08, 2014, 06:36:52 PM
by kbrown5687