Get Answers to your Appliance Repair Questions

Author Topic: Surface Burner Controls?  (Read 1522 times)

Offline 91boz

  • VIP Member
  • Member Since: Feb 2011
  • Posts: 10
Surface Burner Controls?
« on: March 27, 2014, 01:38:40 PM »
I have a White Westinghouse model KF450GDD5 range that needs the 4 top burner controls replaced. The part number for the controls are K001311753. alThis part has been discontinued and is no longer available. All the online parts search shows no sub for this part. The closest part number I found was a universal 5303935086. Does anyone know if this will work?

Offline Wilson13

  • Technician
  • Member Since: Mar 2014
  • Posts: 57
  • Country: us
  • 20+ years appliance service tech,owner from 2002
Re: Surface Burner Controls?
« Reply #1 on: March 27, 2014, 07:49:18 PM »
yes the universal switch will work, the shaft has to be broken to length and the proper plastic insert used, do not brake the shaft too short, theres no going back if you do, also pay close attention to the placement of the wires on the old switch, hopefully it will be marked with p,h1,h2,l1and l2. take one wire off at a time p on old switch goes to p on the new switch, l1 to l1, if the old switch is marked with numbers then you will have to figure out where the wires go. h1and h2 go to the burner,p is a wire that jumps in between each of the four switchs, normally blue or yellow in color. l1 and l2 are normally heavy red or black wires. good luck, hope it goes well.


Hot surface light stays on after using large front burner.

Started by rains

Replies: 1
Views: 2758
Last post May 23, 2012, 03:06:33 PM
by AJ
Jenn Air JES9900BAB burner stuck on high, hot surface light always on

Started by mag381

Replies: 4
Views: 1999
Last post December 13, 2014, 09:19:58 PM
by mag381
thermador cooktop surface burner valve replacement

Started by jjkdiy

Replies: 4
Views: 786
Last post August 09, 2015, 07:23:52 AM
by mz3own
Whirlpool Range - Top Burner Not Working

Started by AJ

Replies: 0
Views: 6658
Last post December 28, 2007, 12:21:08 AM
by AJ
Need help with opening range top for gas stove to replace burner valve.

Started by bobafett13

Replies: 3
Views: 6116
Last post January 24, 2008, 10:57:06 AM
by JWWebster
Kitchenaid Range Hot Surface Light Always On

Started by TechnicianBrian

Replies: 2
Views: 6527
Last post April 16, 2008, 11:37:16 AM
by TechnicianBrian