Author Topic: No water to dispenser on door  (Read 167 times)

Offline spinner101

  • VIP Member
  • Member Since: Feb 2012
  • Posts: 15
No water to dispenser on door
« on: March 21, 2014, 04:35:05 PM »
Maytag S/S refrigerator model RSW2400CAE. There is no water at the dispenser at the door, I have used a jumper wire on the solenoid after I cracked the line under the solenoid and when I plugged it in I had water but when I tightened the line back up and plugged my jumper back in I couldn't get it to come out of the dispenser on the door. Tracing the water line from the valve it goes over to the refrigerator side and goes up inside, there is another line that comes back out and then goes over to the freezer door and up to the dispenser. What does the line that goes up the inside of the back go to? If it is a filter I can't find it. I have looked all over the internet for a water line diagram with no luck. Can anyone please help me. Thanks

Offline Wilson13

  • Technician
  • Member Since: Mar 2014
  • Posts: 57
  • Country: us
  • 20+ years appliance service tech,owner from 2002
Re: No water to dispenser on door
« Reply #1 on: March 21, 2014, 05:39:52 PM »
Sounds like a frozen line.

 

HotPoint S/S Fridge w/built in water dispenser in door

Started by chilicasa@hotmai

Replies: 3
Views: 2296
Last post November 16, 2009, 04:53:36 PM
by chilicasa@hotmai
Kenmore refrigerator - how remove ice/water dispenser front panel

Started by Marvster

Replies: 1
Views: 22896
Last post August 11, 2007, 08:06:07 PM
by AJ
No water from dispenser-ice maker working-replaced valve inlet

Started by Evan

Replies: 2
Views: 3046
Last post August 18, 2007, 05:17:53 PM
by Evan
How remove Kenmore ice/water dispenser housing ??

Started by Marvster

Replies: 1
Views: 3591
Last post October 09, 2007, 07:35:32 AM
by AJ
Maytag refrigerator Ice & water dispenser HELP

Started by nash

Replies: 3
Views: 2854
Last post January 26, 2008, 03:39:27 PM
by nash
Door on ice dispenser will not close

Started by dunenuf

Replies: 2
Views: 1949
Last post June 21, 2008, 01:26:31 PM
by JWWebster