Author Topic: Subzero questions and observations  (Read 156 times)

Offline Ricktec

  • VIP Member
  • Member Since: Feb 2014
  • Posts: 2
Subzero questions and observations
« on: February 10, 2014, 12:13:31 PM »
I have a model 590 and have observed the following.

Changing the cold control setting on the refrigerator side (all the way colder) sometimes takes approximately 20 minutes for the compressor to kick in.  Does the control act like an on\off switch or are there reasons that the compressor would not immediately start?  Or is the control or the sensor going out?

Also, the freezer side compressor is much louder than the refer side.  Is this normal?  The refer side is about as loud as the condenser fan (fairly quiet),  the freezer compressor is much louder.

Offline Ricktec

  • VIP Member
  • Member Since: Feb 2014
  • Posts: 2
Re: Subzero questions and observations
« Reply #1 on: February 13, 2014, 02:26:17 PM »
I was able to reduce the noise substantially (approximately 6+ db) when the freezer side was running.  I used very small pieces of dense foam in a few key spots near the condenser that stopped an annoying and loud harmonic.

 

Subzero Questions Please

Started by phdee

Replies: 16
Views: 2997
Last post September 28, 2009, 09:18:55 PM
by krazytech
550 Subzero ice maker will not stop making ice

Started by pummy

Replies: 3
Views: 3527
Last post May 05, 2009, 07:04:49 PM
by shieldcracker
In door ice maker not working...power questions

Started by sshippee

Replies: 5
Views: 1648
Last post May 10, 2009, 07:42:41 AM
by sshippee
201R Subzero frig only ref charge?

Started by outaluck

Replies: 14
Views: 3396
Last post June 13, 2009, 03:38:30 PM
by JWWebster
SubZero 550 water in refrigerator

Started by dirtrider180

Replies: 9
Views: 3754
Last post February 28, 2010, 04:34:48 PM
by dirtrider180
subzero 532 inlet water valve to ice maker

Started by bjmunroe

Replies: 11
Views: 5685
Last post March 10, 2011, 10:56:44 PM
by bjmunroe