I found the problem. After taking the front off and the drum out I found the start of the problem. There was a 1/4" buildup of lint and somehow the wires that come off the motor wiring harness some of them arced across and melted some of the wires together. I have since blown and vacuumed everything out and tried to figure out some of the wiring. I have a new harness with the red, black, blue, white/red green/yellow, and red. My questions may seem obvious to some of you but I gather the black goes to black, blue to blue, white/red to white red, and green/yellow is ground, from there I'm lost. Where do the 2 red wires in positions 1 & 2 go? I wired everything as I described above and as of right now have the 2 red wires capped off. Dryer seems to run fine. Is this correct or what do I need to do? Again thanks for all the help, input and time you've given me.