Author Topic: wdsr2080daww washer hits bottom  (Read 4969 times)

Offline JWWebster

  • Technician
  • Member Since: Jan 2008
  • Posts: 8781
  • Country: us
  • SublimeMasterJW
    • Buy me a beer through paypal
    • JW's Sublime Appliance Advice
Re: wdsr2080daww washer hits bottom
« Reply #10 on: June 17, 2008, 04:03:32 PM »
They stretch. Yeah the rods break from time to time. But mostly down at the bottom where they hook to the tub gets rusted out.
May the hinges of our friendship
        never grow rusty.

About the icons: The beer is tip link, if a tech saves ya some money buy em a 6 pack. The small green square=personal message. The green dot is a link to my web page on appliance repair and other general BS I love to post. The letter sends me email.
I love fan letters! LOL

Offline JPG

  • VIP Member
  • Member Since: Nov 2007
  • Posts: 142
Re: wdsr2080daww washer hits bottom
« Reply #11 on: June 21, 2008, 11:11:22 AM »
HI well it looks like the springs were worn out on this washer i replaced the 2 black rods and it did not work than I bought 2 yellow rods and it worked the yellow rods lift the structure about an inch higher than the black ones....  tks for tour help !    JPG

 

Whirlpool Washer is leaking from bottom in the center

Started by Pagegurl

Replies: 5
Views: 5152
Last post January 04, 2009, 04:30:41 PM
by jumptrout51
Older Kenmore washer - tub bottom gasket replacement - help needed.

Started by colohigh

Replies: 6
Views: 5329
Last post December 19, 2009, 06:14:51 AM
by Repair-man
Washer leaks from the bottom

Started by chuck1385

Replies: 1
Views: 2248
Last post February 08, 2011, 11:06:39 AM
by AJ
Whirlpool Ultimate Care II Washer leaking water from bottom

Started by heathermoler

Replies: 5
Views: 4701
Last post August 29, 2012, 08:30:12 PM
by JWWebster
GE washer GTAN2800D0WW pulley scraping on bottom cabinet

Started by centralappliance

Replies: 1
Views: 529
Last post May 28, 2013, 05:53:26 PM
by Spannerwrench
My Kenmore washer leaks from the bottom

Started by kmp1067

Replies: 6
Views: 545
Last post August 24, 2014, 10:19:58 AM
by kmp1067