Get Answers to your Appliance Repair Questions

Author Topic: GE Gas Range - No Bake  (Read 1343 times)

Offline resapp

  • VIP Member
  • Member Since: Sep 2011
  • Posts: 34
GE Gas Range - No Bake
« on: January 21, 2014, 03:39:04 PM »
I am looking at a GE gas range, model #JGB500DEP3BB, with a no bake issue. It has a manual lock which the owner engaged and put into self-clean. She advised the oven was heating but after 1-2 hours noticed that it had cooled down and she was able to disengage the lock. The oven will broil but there is no voltage coming from the board to the bake igniter. In addition, I was unable to find any voltage to ground at the harness disconnect immediately prior to the igniter.

I replaced the ERC board still have no voltage to the igniter. I suspect there must be a thermal cutoff fuse but the wiring diagram is missing and the parts diagram/list does not list one. Does anyone know if there is a fuse and if so where it is located?

Any help is much appreciated.


Offline AJ

  • Technician
  • Member Since: Jun 2007
  • Posts: 10795
  • Country: us
    • - Appliance Repair
Re: GE Gas Range - No Bake
« Reply #1 on: March 09, 2014, 02:35:06 PM »
resapp, what ended up being the problem?


Whirlpool Electric Range - Bake Cycle Not Working

Started by AJ

Replies: 0
Views: 6605
Last post January 01, 2008, 03:44:30 PM
by AJ
Whirlpool Range Bake Element Not Heating

Started by TechnicianBrian

Replies: 0
Views: 4240
Last post April 08, 2008, 07:08:16 AM
by TechnicianBrian
Frigidaire Range no Bake or Broil

Started by TechnicianBrian

Replies: 0
Views: 5146
Last post May 13, 2008, 09:48:19 PM
by TechnicianBrian
Hotpoint Range no Bake or Broil

Started by TechnicianBrian

Replies: 0
Views: 4134
Last post May 18, 2008, 07:42:18 AM
by TechnicianBrian
Maytag PGR5710BDQ Gas Range, Flashing lock light when bake or broil is pressed

Started by straycatt

Replies: 4
Views: 9029
Last post June 14, 2008, 11:19:00 AM
by straycatt
Roper Range will not bake!!!Help

Started by ffmedicmt

Replies: 5
Views: 3796
Last post August 08, 2008, 11:58:29 AM
by Al Capone