Author Topic: Kenmore washer 80 series model 110.24642300 does not drain  (Read 428 times)

Offline dnnsmrgn

  • VIP Member
  • Member Since: Jan 2014
  • Posts: 1
Kenmore washer 80 series model 110.24642300 does not drain
« on: January 03, 2014, 07:10:27 PM »
Machine will fill to proper level, agitate and spin but never drains water on all cycles. I Have already pulled tub an checked hoses. It stops briefly before spin cycle but then spins . I am not sure of sequence of events to take place . Does it drain during spin cycle or before spin cycle, was thinking possibly faulty timer for not allowing enough time for drainage or pump.

Offline fairbank56

  • Technician
  • Member Since: Aug 2012
  • Posts: 357
  • Country: us
Re: Kenmore washer 80 series model 110.24642300 does not drain
« Reply #1 on: January 03, 2014, 08:04:26 PM »

  Then either the pump is faulty or the motor shaft has rounded off. The pump is running any time the drive motor is running. In spin cycle, it runs in a direction that should pump the water out. If all hoses are clear and there's nothing blocking the drain hole at bottom of tub, then the pump is bad (assuming motor shaft is ok).

Eric

 

kenmore washer series 70 model 110.20702990 won,t drain

Started by HORN 34

Replies: 1
Views: 1697
Last post February 21, 2009, 01:22:44 PM
by JWWebster
Looking for manual of Kenmore washer 70-series model # 82873120

Started by newbie123

Replies: 3
Views: 5181
Last post June 15, 2010, 09:10:02 PM
by newbie123
Kenmore 60 Series Washer - Won't spin or drain

Started by annettemd

Replies: 1
Views: 4109
Last post January 26, 2011, 10:41:36 AM
by whirlpooltech
Kenmore 80 Series Washer

Started by shawnrconnelly

Replies: 5
Views: 5309
Last post October 25, 2007, 09:46:52 AM
by Pegi
whirlpool washer model LXR9245EQ1- won't drain-slow spin

Started by fixmeplz

Replies: 2
Views: 6196
Last post January 16, 2008, 10:13:02 PM
by JWWebster
Kenmore Washer will not drain or spin, agitates on the agitate lo cylce only

Started by mattz

Replies: 5
Views: 9014
Last post March 11, 2008, 09:21:43 AM
by mattz