Free Service - Appliance Repair Help & Troubleshooting

Author Topic: Oven Does Not Stay On  (Read 986 times)

Offline borgward

  • VIP Member
  • Member Since: May 2008
  • Posts: 1
Oven Does Not Stay On
« on: December 29, 2013, 11:25:59 AM »
Kenmore Model 911.41065791
 
The oven turns off after 15 minutes. I can turn it back on, but it stays on for a shorter time, I can turn it on again but it immediately turns off. No error codes. I suspect the temperature sensor. Some times the oven will stay on a long time. The temperature seems reasonable. Could there be any other causes? I unplugged the sensor to see if the connection looked dirty. It was clean.

 How can I test the sensor? I could remove the sensor and heat it to a known temperature aand then check for voltage or resistance.

Offline dab147315

  • Technician
  • Member Since: Oct 2010
  • Posts: 3179
  • Country: us

Offline tgoods

  • Technician
    Moderator
  • Member Since: Jul 2010
  • Posts: 1744
  • Country: us
    • Buy me a beer through paypal
Re: Oven Does Not Stay On
« Reply #2 on: December 30, 2013, 12:37:50 AM »
When it doesn't stay on, what does it do? Does it act like it preheated or does the display go blank.  It sounds to me like the control board is bad.  The part number is WB27K5273.  It's no longer available but it can be rebuilt.

 

Frigidaire Gas Range Oven Wont stay lit

Started by rjsp

Replies: 4
Views: 173
Last post June 08, 2016, 07:44:02 PM
by rjsp
Frigidaire oven temp sensor probe?

Started by jon

Replies: 1
Views: 9491
Last post July 08, 2007, 06:06:26 PM
by AJ
Jenn-Air self cleaning oven problem

Started by ralphthedog

Replies: 6
Views: 14931
Last post December 13, 2007, 08:15:34 PM
by ralphthedog
How can I find the manual for a Jenn Aire double oven?

Started by Dukes

Replies: 2
Views: 5263
Last post December 16, 2007, 04:40:06 PM
by Dukes
Maytag Double Wall oven lights

Started by jumptrout51

Replies: 2
Views: 6535
Last post December 23, 2007, 01:26:06 PM
by kjagmin
bosch convection oven

Started by JPG

Replies: 1
Views: 5133
Last post December 20, 2007, 09:19:33 AM
by Pegi