Author Topic: Agitator slips do I need directional cogs or kit or agitator  (Read 465 times)

Offline ron3033

  • VIP Member
  • Member Since: Feb 2013
  • Posts: 21
  • Country: ca
Agitator slips do I need directional cogs or kit or agitator
« on: December 15, 2013, 08:13:32 PM »
Sears Kenmore 90 series top loader  #110 20912 991

Seems like the upper half of the agitator slips when a large load was being washed.  It might sort of slip every 4 or 5 turn.  I took the cap off and undid the cam affair,  It had a bit of white powder.  I suspect that the directional cogs are wearing down, they do not seem to be real sharp where they would engage the teeth inside the upper agitator.
I assume all I need is the directional cogs (dog ears) ... are they available to fit this model?  Or do I have to buy a whole new cam assembly?  I would not think that the teeth inside the upper agitator are gone, but I better get expert advice.  I am hoping just the directional cogs.

Thank You
ron3033

Offline tgoods

  • Technician
    Moderator
  • Member Since: Jul 2010
  • Posts: 1511
  • Country: us
    • Buy me a beer through paypal
Re: Agitator slips do I need directional cogs or kit or agitator
« Reply #1 on: December 15, 2013, 11:04:31 PM »
You probably just need the dogs, 80040. Occasionally I'll see a broken cam, in which case you would need the cam kit, 285810. I've never seen stripped teeth in the upper agitator.

Offline ron3033

  • VIP Member
  • Member Since: Feb 2013
  • Posts: 21
  • Country: ca
Re: Agitator slips do I need directional cogs or kit or agitator
« Reply #2 on: December 16, 2013, 10:34:32 AM »
Thanks  I thought Iwas on the right track, but wanted to check with somoeone else.

Thank you
ron

Offline ron3033

  • VIP Member
  • Member Since: Feb 2013
  • Posts: 21
  • Country: ca
Re: Agitator slips do I need directional cogs or kit or agitator
« Reply #3 on: December 17, 2013, 08:44:37 AM »
Fixed, a real easy two minute job.   Thanks again!

 

Video: How to replace the "Dogs" in your Whirlpool washer agitator.

Started by AJ

Replies: 1
Views: 10479
Last post May 25, 2008, 11:09:16 PM
by jean
agitator not spinning

Started by whit

Replies: 2
Views: 2518
Last post October 22, 2007, 06:21:57 PM
by Pegi
Whirlpool washer LSQ9010KQ0...Can't seperate Agitator

Started by Matt F.

Replies: 5
Views: 4159
Last post December 16, 2007, 06:09:05 PM
by AJ
Agitator only spins one way

Started by will_m

Replies: 2
Views: 3686
Last post February 20, 2008, 06:00:55 PM
by will_m
Agitator shaft agitated.

Started by dwhite65

Replies: 2
Views: 1689
Last post February 26, 2008, 10:07:28 AM
by dwhite65
Amana washer agitator rattles during spin cycle

Started by suec

Replies: 7
Views: 6861
Last post July 15, 2008, 08:43:36 AM
by JWWebster