Hello everyone. I have an Electrolux Dryer in a rental house, that I noticed was randomly blinking LEDs and beeping. Naturally, I pulled the lint screen and was shocked to see the cavity below it was almost completely stopped up! I took the dryer apart and cleaned everything. When I put it all back together, it still blinked and beeped. Since then, I found the procedure for Codes and Run Tests. There's no doubt it is giving a Code 62, which I cannot find online,
. I sent message to Electrolux and they answered....
"The 62 code means that the control panel has detected a heat relay failure."
They went on to suggest I contact an Authorized Service Provider. (Isn't that what I'm doing posting here?) I've done maintenance work all my life and have 8 years of Electronics in the military. When I did the Run Tests, I could not make heads or tails of the Thermistor Temperature blinking LEDs. I used my Temp Gun and got about 150-degrees in the Drum. Is this about right? This Heat Relay is mounted on the Control Board. I'd hate to spend the $130, or so, only to still get a Code 62. Any help greatly appreciated.