I see lots of posts about the dishwasher blinking but could not see my particular situation. Hope you can help me.
I had the wiring harness replaced a couple of years ago for a recall and I believe the man removed my model no.
I have a sticker on the main control board with the part number.
On to my problem-----When I close the washer I have a blinking light on the start/reset button.can hear the sequence switch advancing but no pump or water going in or anything. If I dont touch it it will advance further in a few minutes and finally all, the options will light up like it is ready to go but when I push the start/reset button that button blinks forever.
At this point I'm hoping it to be the control board rather than the sequence switch as I dont have the part number for the switch.
What do you think?