365-Day Hassle Free Return Policy!  ·  AppliancePartsPros.com
Washer PartsDryer PartsRefrigerator PartsDishwasher PartsRange & Oven PartsAll Appliance Parts

Author Topic: GE DPSR610EG0WT dryer - Timer doesn't advance in Auto  (Read 997 times)

Offline olyteddy

  • Technician
  • Member Since: Jul 2012
  • Posts: 265
  • Country: us
GE DPSR610EG0WT dryer - Timer doesn't advance in Auto
« on: November 24, 2013, 02:12:58 PM »
Checked vent (good flow); replaced control inlet and drum outlet thermostats; temperature at filter inlet varies from 120 to 180 degrees; heaters both 19.5 ohms. Also substituted heat selector, timer and EOC signal board from a known to work dryer. This machine doesn't have a separate 4500 ohm resistor to drop the voltage for the timer. It appears to be part of the EOC board and reads 4500 ohms. Also, on the schematic there appears something called a top rod and a bottom rod. Does the Auto on this machine operate differently than the traditional method of getting timer motor current from the heating coils? Perhaps the top rod and bottom rod comprise some sort of moisture sensor?

Offline dab147315

  • Technician
  • Member Since: Oct 2010
  • Posts: 2351
  • Country: us
Re: GE DPSR610EG0WT dryer - Timer doesn't advance in Auto
« Reply #1 on: November 24, 2013, 07:26:50 PM »
You replace this board and clean the moisture sensor bars and it still does not shut off in auto cycle?And in time cycle it dry in 60 minutes or less.http://www.appliancepartspros.com/ge-board-w-buzzer-we04x10102-ap3421740.html

Offline Jdm

  • Technician
  • Member Since: May 2011
  • Posts: 133
  • Country: us
Re: GE DPSR610EG0WT dryer - Timer doesn't advance in Auto
« Reply #2 on: November 24, 2013, 07:36:58 PM »
One of the elements is bad. It will work on time but not on auto.
It's not the legacy you leave, it's the lives you impact


Ge Dryer drsr495eg8ww timer won't advance in auto

Started by schleven

Replies: 13
Views: 3719
Last post June 07, 2012, 01:26:24 PM
by schleven
Dryer timer does not advance

Started by Ryan

Replies: 4
Views: 3719
Last post September 08, 2008, 01:23:39 PM
by Ryan
Admiral ADG7000AWW Gas dryer timer not advancing in auto cycles

Started by lucasskywalker1

Replies: 0
Views: 275
Last post January 30, 2015, 08:57:38 AM
by lucasskywalker1
IA84600 Inglis dryer doesn't heat

Started by RickT

Replies: 5
Views: 9511
Last post January 16, 2008, 04:02:42 PM
by JWWebster
Frigidaire Dryer Timer Knob p/n 1340354 black

Started by nivard

Replies: 6
Views: 9309
Last post March 31, 2008, 01:34:26 PM
by RegUS_PatOff
Whirpool dryer timer Part#: 691376 (needed)

Started by jet713

Replies: 7
Views: 3577
Last post November 08, 2014, 11:48:39 AM
by markcoby98