Author Topic: LG Electric Dryer dle5977w No heat  (Read 412 times)

Offline snuddenstang

  • VIP Member
  • Member Since: Sep 2013
  • Posts: 3
LG Electric Dryer dle5977w No heat
« on: September 25, 2013, 09:08:59 PM »
I have an LG DLE5977W electric dryer.

It runs fine but doesn't heat up. When running, the "Dry" light flashes and the "Cooling" light stays lit.

I have tested the following components:
Thermal Fuse: 0/.1 ohm
High limit thermostat: 0/.1 ohm
Themostat (blower unit): 0 ohm
Thermistor (blower unit): 12k ohms (when not running)
Heating Element: Red/Blue: 19.9 ohms; Red/Yellow: 19.9 ohms; Blue/Yellow: 40.0 ohms

I replaced the thermistor since it wasn't always giving me a consistent reading, but that didn't fix it.

I'm getting 110vac on each leg and off the motor assembly, and I know the 220 outlet is good.

In diagnostic mode, I get the following code: 18:F0 / U01.

I replaced the Main Control Board, figuring it was the only thing left. But that didn't work either.

Any other ideas?! Thanks...

Offline john63

  • Technician
  • Member Since: Feb 2010
  • Posts: 446
Re: LG Electric Dryer dle5977w No heat
« Reply #1 on: September 26, 2013, 01:29:02 AM »
<<<In diagnostic mode, I get the following code: 18:F0 / U01.>>>

**********

Software ID number---not important.

I would check the voltage at the Terminal Block (220v at both sides)

Check for burned wiring at the Terminal Block.

Unplug dryer.

By-pass the Thermal Limiter AND the Hi Limit Thermostat---plug in and test-run the dryer.
If heater works---replace both (6931EL3003D) and (6931EL3001F)

Re-Verify that the Motor Centrifugal Switch is indeed "good"...

Unplug dryer.

Pull plug off motor

On the *belt & pulley* side of the motor---there's a *black ring* on the motor shaft.
This ring slides inward when the motor reaches speed.
Using your finger---slide the ring towards the blower-slide of motor and hold it there.
Measure continuity at the Motor plug connector on the side of the motor (centrifugal switch)--check for continuity on the farthest-to-the-left pin and the farthest-to-right pin (none of the other motor connector pins matter for this test). It should show continuity---if not---replace Motor.

Offline snuddenstang

  • VIP Member
  • Member Since: Sep 2013
  • Posts: 3
Re: LG Electric Dryer dle5977w No heat
« Reply #2 on: September 26, 2013, 06:10:47 AM »
I checked for 220v and that is OK.

How do I By-pass the Thermal Limiter AND the Hi Limit Thermostat?

I will check the motor today.


Offline snuddenstang

  • VIP Member
  • Member Since: Sep 2013
  • Posts: 3
Re: LG Electric Dryer dle5977w No heat
« Reply #3 on: September 26, 2013, 06:34:16 AM »
I just checked the motor and do not have continuity on the left and right lugs when sliding the ring over.  I will replace the motor.

 

Kenmore 70 series electric dryer...wont heat

Started by lalakelley

Replies: 53
Views: 34336
Last post November 24, 2011, 02:40:03 AM
by RegUS_PatOff
Kenmore electric dryer no heat

Started by pcornelius

Replies: 3
Views: 3523
Last post May 30, 2008, 11:44:50 AM
by RegUS_PatOff
Maytag electric dryer won't heat

Started by coolair

Replies: 6
Views: 1894
Last post January 10, 2009, 10:19:19 AM
by JWWebster
70 series Kenmore electric dryer spins but does not heat

Started by llew_x

Replies: 52
Views: 37038
Last post July 23, 2013, 08:25:04 AM
by JWWebster
LG electric dryer spins no heat

Started by brockinfla

Replies: 3
Views: 5401
Last post May 20, 2009, 12:08:41 AM
by PARTech
Kenmore 70 series electric dryer no heat again

Started by weadhopper

Replies: 5
Views: 3882
Last post May 14, 2009, 11:13:08 PM
by JWWebster