Author Topic: Washer spin cycle not always completing  (Read 443 times)

Offline twmattox

  • VIP Member
  • Member Since: Mar 2009
  • Posts: 11
Washer spin cycle not always completing
« on: September 12, 2013, 03:35:41 PM »
I have the Neptune washer (MAH4000AWW).  I replaced the bearings in early 2010.  I noticed at the time that I have the "good" wax motor. 

The issue I am having now is that sometimes (not always) the washer will stop mid cycle.  It doesn't always do it at the same place.  Sometimes just before the spin cycle starts, sometimes just after one of the spin cycles, sometimes after several spin cycles.  If I hit the start button, things will start again.  But, sometimes (not always) it will stop again after the next spin cycle or two.

Not sure where to look or what to consider.  It doesn't have any real rhyme or reason to it.  I have tried larger than normal loads, smaller than normal loads, hot water, cold water...and no changes.  Sometimes works great...others not so much.


Offline jason1979g

  • Technician
  • Member Since: Jul 2013
  • Posts: 193
  • Country: us
Re: Washer spin cycle not always completing
« Reply #1 on: September 12, 2013, 07:46:17 PM »


Maytag washer mah4000aww spin cycle

Started by evo100

Replies: 1
Views: 4119
Last post December 25, 2007, 09:41:02 PM
by AJ
washer works except spin cycle and has a burning rubber smell.

Started by hogslayer

Replies: 4
Views: 5625
Last post February 19, 2008, 03:50:55 PM
by JWWebster
Maytag washer-- got agitation, no spin in spin cycle

Started by PB3

Replies: 13
Views: 14621
Last post March 28, 2008, 09:18:30 AM
by PB3
washer trips gfi at spin cycle

Started by rhartman93643

Replies: 7
Views: 4682
Last post April 18, 2008, 11:57:24 AM
by rhartman93643
washer wont spin and sometimes shuts off mid cycle

Started by imharley

Replies: 14
Views: 10869
Last post June 12, 2012, 07:56:35 PM
by Bailey
Amana washer agitator rattles during spin cycle

Started by suec

Replies: 7
Views: 7605
Last post July 15, 2008, 08:43:36 AM
by JWWebster