Author Topic: Maytag Neptune MAH8700AWW "ND", Replaced Drain Pump, Still Not working  (Read 2089 times)

Offline Charles Noble

  • VIP Member
  • Member Since: Aug 2013
  • Posts: 1
Hope somebody can point me in the right direction. My Maytag MAH8700 was delivering the "ND" code, I replace the drain pump once before and examined it again. I found the housing filled with dirty/black water (probably a bad gasket) and concluded that this may well have been my issue. I installed the new drain pump, but the results were the same, ND.
In "Service Mode" I performed the Board Input and Board Output test, all tested fine except two. On the Board Output when trying to test the Main Relay I receive a code of "ot", also when testing the Drain Pump I am getting the same "ot" code (pump NOT turning on or off).

I can't seem to find any reference for what "ot" means and what my next step should be. Any help would be appreciated.


Maytag Neptune MAH8700AWW ND code - replaced drain pump

Started by slmorgan99

Replies: 3
Views: 7378
Last post September 10, 2012, 09:58:00 AM
by Bailey
Maytag Neptune Drain Pump

Started by toey

Replies: 2
Views: 2155
Last post December 14, 2011, 05:39:44 PM
by toey
Video of Maytag Neptune Washer making a "chirping" sound

Started by nategoyer

Replies: 4
Views: 3278
Last post August 26, 2012, 09:14:15 AM
by twayneb
Maytag Neptune MAH4000AWW Won't Drain Water / Smell

Started by mightymac

Replies: 22
Views: 32617
Last post February 15, 2013, 04:35:03 PM
by def
16025909 Maytag MAH9700AW 27" Front Load Washer Service Repair Manual

Started by AJ

Replies: 0
Views: 8974
Last post June 03, 2008, 07:37:03 AM
by AJ

Started by stacy2

Replies: 4
Views: 8977
Last post June 15, 2008, 09:18:30 PM
by stacy2