Free Service - Appliance Repair Help & Troubleshooting

Author Topic: Whirlpool Tub Wrench  (Read 701 times)

Offline Maytag Man 6725

  • Technician
  • Member Since: Jul 2014
  • Posts: 396
  • Country: us
  • Technician since 1990
Whirlpool Tub Wrench
« on: March 13, 2016, 09:09:43 AM »
So, I'm looking for some feedback. For the last year or so, I've been using a 1 11/16 deep impact socket with an electric impact to remove GE washer tub nut. Squeeze the trigger and a few seconds later, it's out. Beats the snot out of beating on a wrench with a hammer for many minutes. This method works so well that I am wanting to know if many would be interested in a deep impact socket for the Whirlpool tub nut??

Offline afterblast

  • Technician
  • Member Since: Feb 2013
  • Posts: 240
  • Country: us
Re: Whirlpool Tub Wrench
« Reply #1 on: March 13, 2016, 12:10:39 PM »
I use the deepwell socket for ge's...    for the whirlpool tub nut you can use a 2-1/2 spindle nut socket.   it's just barely tall enough, and has a little slack, but the next size down is slightly too tight.  it's meant for use on 4 wheel drive stuff...   I took an extra nut from an old vma washer gearcase change in with me to test the fit... used it a couple times and it does the trick.  found it at Orielly  for around 20$ but can't remember exactly how much.


spindle nut at orielly

if the link doesn't work it's part # w1273   spindle nut by performance tool

 

Crescent 6" & 10" RapidSlide Adjustable Wrench?

Started by AJ

Replies: 1
Views: 2148
Last post March 05, 2013, 11:32:49 AM
by AJ
Channellock 804 & 804N Adjustable Wrench

Started by AJ

Replies: 4
Views: 2717
Last post September 23, 2013, 08:58:26 PM
by theoldstoveguy
Whirlpool Dishwasher Membrane tester

Started by dab147315

Replies: 3
Views: 2149
Last post April 12, 2015, 10:52:29 AM
by apreca11