IMPORTANT: Calibration must be performed
when any of the following components have
been replaced: Main Control, Basket, Drive
Assembly, Suspension, Motor, and Capacitor.
Not performing calibration will result in poor
To access Calibration Mode, perform steps
1 and 2 of Activating the Service Diagnostic
Modes. Turn the cycle selector knob until the
status LEDs or display correspond as follows:
RinseĒ LED On, ď04Ē Displayed on 7-segment
Press the START button to begin washer
calibration. All status LEDs will turn on.
Do NOT interrupt calibration, disturb washer,
or remove power; otherwise, calibration
must be repeated.
id must be down to perform test.
asket must be empty to perform test
(no water or clothes).
alibration cycle runs for approximately
2-4 minutes. Cycle completes when door
unlocks and washer enters standby mode.