Author Topic: Whirlpool Washer Jumping Around  (Read 666 times)

Offline app1

  • Technician
  • Member Since: Aug 2011
  • Posts: 187
Whirlpool Washer Jumping Around
« on: July 15, 2013, 03:48:55 PM »
Hello, I am working on a Whirlpool Washer Model # WTW6600SW1 and it seems fine in spin and rinse but about half way through a wash cycle it begins to jump around and bang a little bit and then it shuts off and it looks like an error code of uL, I gues that would be unbalanced load? However, it has no clothes in it.. What am I looking at to fix this problem.. Thanks In Advance For Any Help!!!!

Offline Spannerwrench

  • Technician
  • Member Since: May 2012
  • Posts: 74
Re: Whirlpool Washer Jumping Around
« Reply #1 on: July 15, 2013, 05:44:43 PM »
Open the door and lift up on the inner basket, wiggle it around some and see if it shakes.  Make be a bad spinner, basket, bearing and outer drum.

Offline app1

  • Technician
  • Member Since: Aug 2011
  • Posts: 187
Re: Whirlpool Washer Jumping Around
« Reply #2 on: July 15, 2013, 06:26:19 PM »
Thanks Spannerwrench I will check that and somebody said maybe shocks or the balls on top? Not sure if that makes any sense but I will check the basket.. Thanks
 

 

Repair Guide: Whirlpool Direct Drive Washer - No agitate or spin

Started by AJ

Replies: 13
Views: 28869
Last post January 02, 2009, 01:09:38 PM
by AJ
Video: Whirlpool Washer Motor - Bad connection..

Started by AJ

Replies: 3
Views: 3298
Last post July 29, 2013, 06:32:05 PM
by AJ
Video: Whirlpool Made Direct Drive Washer Motor Coupler Replacement

Started by AJ

Replies: 18
Views: 43451
Last post May 18, 2010, 06:53:50 AM
by gimpyjones
Video: How To Replace a Water Pump On A Whirlpool Made Direct Drive Washer

Started by AJ

Replies: 0
Views: 8887
Last post August 10, 2007, 08:42:54 PM
by AJ
whirlpool belt drive washer won't spin

Started by mthd60sprty

Replies: 7
Views: 7650
Last post June 06, 2013, 08:42:12 AM
by fairbank56
Whirlpool washer not agitating

Started by jdman

Replies: 25
Views: 29405
Last post January 18, 2013, 10:28:43 PM
by AJ