Author Topic: Wh38x10017 mode shifter bearing replacing  (Read 687 times)

Offline NITROITCH

  • VIP Member
  • Member Since: Jun 2013
  • Posts: 6
Wh38x10017 mode shifter bearing replacing
« on: July 09, 2013, 09:29:13 PM »
Has anyone replaced the RS6006 bearing which is available from most industrial bearing suppliers. My shaft mode assembly is performing properly in the engage and disengagement process, but the tub seal failed resulting the tub sleeve bearing wearing and gauling, and the RS6006 bearing inside the mode shifter is also not spinning smoothly. I disassembled the assembly and I am ready to press out the bearing, but before I do, just wanted to see if anyone has successfully done this.

 

MANUAL OR DIRECTIONS FOR REPLACING BEARING & SEAL HOUSING KIT

Started by JOHNW

Replies: 5
Views: 2596
Last post January 22, 2010, 09:55:10 PM
by schaffersapplian
mode shifter

Started by gkofc

Replies: 14
Views: 7477
Last post February 16, 2010, 09:34:50 AM
by JWWebster
31-9145 Profile Washers With Electronic Control and Mode Shifter Assembly Service Manual

Started by AJ

Replies: 0
Views: 661
Last post December 30, 2012, 10:45:17 AM
by AJ
GE Hydro Wave Washer -Mode Shifter Ghetto Repair

Started by goodsusedappliance

Replies: 30
Views: 7934
Last post November 17, 2014, 05:26:32 PM
by wanderingturtle
Maytag Washer Bearing Repalcement MLG2000AWW

Started by davidpgh1

Replies: 8
Views: 11018
Last post January 06, 2008, 01:59:10 PM
by inot66
Maytag Frontloader bearing replacement

Started by mattD110td5x

Replies: 2
Views: 4679
Last post October 11, 2007, 04:41:26 PM
by mattD110td5x