Author Topic: LG Tromm WM2277HW Spins at start but won't begin cycle - Intermittently  (Read 1446 times)

Offline APG85

  • VIP Member
  • Member Since: Feb 2013
  • Posts: 22
  • Country: us
 My LG Tromm will spin (when I push start), but won't start the cycle (just keeps spinning)...intermittently. I have to turn off the power switch, turn it back on, reset the wash cycle and try again.  Sometime I have to do this 3-8 times to get the cycle going.  Sometimes, I have no problems at all and it starts right up into the wash cycle. Once the wash cycle starts, it washes and runs through the full cycle without any problems.  I replaced the Hall Sensor and I'm still having the same issue.

Is this the Control Board / Main PCB going bad?  Where is that located, what is the part number and how do you replace it...?

Thanks for the help.

Offline wildimaginations

  • Technician
  • Member Since: Jul 2011
  • Posts: 618
  • Country: us
Pull the plug and wait 5 minutes.  Plug it back in and go into test mode.  Then try a normal wash cycle.
Appliance Service Technician
Authorized servicer on LG appliances.
About 45 mins east of San Francisco

Offline APG85

  • VIP Member
  • Member Since: Feb 2013
  • Posts: 22
  • Country: us
Thanks, but there's no Test Mode that I can figure out (no button or switch) unless you have to select a sequence of buttons or something...?  I looked in the owners manual and it doesn't say anything about how to put the machine in Test Mode... 

Offline john63

  • Technician
  • Member Since: Feb 2010
  • Posts: 496
 My LG Tromm will spin (when I push start), but won't start the cycle (just keeps spinning)...intermittently.

************

This symptom is consistent with...

Main Board awaiting data/signal feedback from the Hall Effect Sensor but---does not receive it (trying to determine weight of laundry for correct amount of water fill).

Replace the Wire Harness which runs/routes from the base of the washer---to the Stator and Hall Sensor.

6877ER1016D

Offline APG85

  • VIP Member
  • Member Since: Feb 2013
  • Posts: 22
  • Country: us
Thanks for the tip on the wire harness.  How do I access this?  Is it a simple matter of pulling the back off the machine and going from the Hall Sensor and following it back...?

Offline john63

  • Technician
  • Member Since: Feb 2010
  • Posts: 496
Yes---very simple.

Offline APG85

  • VIP Member
  • Member Since: Feb 2013
  • Posts: 22
  • Country: us
Ok, thank you...

 

LG Tromm WM2277HW Spins but won't start cycle

Started by APG85

Replies: 18
Views: 4587
Last post June 29, 2013, 01:17:01 PM
by APG85
Kenmore 300 fills on cycle start spins and drains but no rinse or short cycles

Started by kenmore300

Replies: 9
Views: 2960
Last post September 29, 2009, 07:18:00 AM
by Repair-man
LG TROMM WM2277HW LOUD TAPPING DURING SPIN CYCLE

Started by dhogfoss

Replies: 9
Views: 4305
Last post February 03, 2013, 07:11:19 PM
by wildimaginations
washer stopped in the middle of a cycle and won't start again

Started by tetsuo73

Replies: 22
Views: 14474
Last post November 02, 2008, 09:02:18 AM
by AJ
frigidaire washer smoking and only spins on rinse cycle

Started by jazzly

Replies: 3
Views: 3535
Last post November 09, 2008, 09:51:21 AM
by Repair-man
Washer makes fast tapping noise at start of spin cycle

Started by Rubik

Replies: 9
Views: 5633
Last post May 04, 2009, 09:03:24 PM
by JWWebster