Author Topic: Maytag Neptune MAH8700AWW with ND code  (Read 794 times)

Offline rs92777

  • VIP Member
  • Member Since: Jun 2013
  • Posts: 1
Maytag Neptune MAH8700AWW with ND code
« on: June 08, 2013, 02:35:12 PM »
So we have been getting the ND code on our washing machine.  We downloaded the service manual and did some of the tests.  The pump isn't getting 120 VAC during the spin cycle so we checked the voltage at the pin 6 CN10 and pin 1 CN5 and it isn't getting 120 VAC either.  So what is wrong?  Could it be a loose wire or is it the control panel itself, or could it be a sensor?

Offline tgoods

  • Technician
    Moderator
  • Member Since: Jul 2010
  • Posts: 1450
  • Country: us
    • Buy me a beer through paypal
Re: Maytag Neptune MAH8700AWW with ND code
« Reply #1 on: June 08, 2013, 03:32:38 PM »
It looks like a bad control board.  Check for a shorted pump motor, it should be 14.2 ohms +/- 7%. Make sure it's within specs, I once blew up a new control with pump that read 12 ohms. With the cost of a new board, it might be worth trying a board repair or having it rebuilt.

 

Maytag Neptune MAH8700AWW ND code - replaced drain pump

Started by slmorgan99

Replies: 3
Views: 3379
Last post September 10, 2012, 09:58:00 AM
by Bailey
Maytag Neptune TL Washer UC Error Code

Started by TechnicianBrian

Replies: 0
Views: 21030
Last post October 14, 2008, 06:38:41 AM
by TechnicianBrian
Maytag Neptune Lr code and now door lock problems

Started by anniechoco

Replies: 2
Views: 8441
Last post December 07, 2008, 09:01:38 AM
by anniechoco
Maytag Neptune uC error code

Started by salida

Replies: 17
Views: 7806
Last post October 07, 2010, 10:36:31 AM
by dh1200s
MAH8700AWW maytag neptune motor

Started by jlittman

Replies: 3
Views: 1755
Last post April 21, 2012, 01:46:39 PM
by AJ
Maytag Neptune MAH5500BWW LR code

Started by FlyinBri

Replies: 13
Views: 9130
Last post December 29, 2011, 07:51:43 PM
by FlyinBri