Author Topic: GE Oven doesn't reach temperature (120-150 Below setting)bAKE  (Read 5286 times)

Offline Earl Dryer

  • Technician
  • Member Since: May 2008
  • Posts: 166
  • Country: us
The oven sensor is 1100 ohms all the wiring and connection are good, both elements turn on, Broiler on Hi heats the oven to 340-350,
Bake heats oven to 210 when set to 350 and 350 when set at 500.
Both element show 2-3 ohms diagrams with range show broiler  to be 16 ohms & bake to be 22 ohms. I think my problem is the control board but I cannot find any part breakdowns for this thing.  
 
Thanks,
Earl

Model JDC27G0P1BG

Offline JWWebster

  • Technician
  • Member Since: Jan 2008
  • Posts: 8780
  • Country: us
  • SublimeMasterJW
    • Buy me a beer through paypal
    • JW's Sublime Appliance Advice
Re: GE Oven doesn't reach temperature (120-150 Below setting)bAKE
« Reply #1 on: May 30, 2008, 02:01:51 PM »
Cl/ov control

Part Number: AP2025110 made by GE
 
 
 
 Availability:
Requires special attention
Please give us a call at
1-877-477-7278

 Take the 0 out of the model number. JDC27GP1 I use appliance parts pros. put the model number in in that APP search box and you will get this message . It is in section 3.
« Last Edit: May 30, 2008, 02:08:02 PM by JWWebster »
May the hinges of our friendship
        never grow rusty.

About the icons: The beer is tip link, if a tech saves ya some money buy em a 6 pack. The small green square=personal message. The green dot is a link to my web page on appliance repair and other general BS I love to post. The letter sends me email.
I love fan letters! LOL

Offline Earl Dryer

  • Technician
  • Member Since: May 2008
  • Posts: 166
  • Country: us
Re: GE Oven doesn't reach temperature (120-150 Below setting)bAKE
« Reply #2 on: May 30, 2008, 02:14:14 PM »
Thank you AJ, that was the 1st place I looked, There are no illustrations and most of the parts are listed as unknown part, Have any suggestions of which part is the right one. Thanks


PS I was a tech 20 some odd years ago. Came out of retirement we
have no repair people in this area, so here I am. Technology is different basics are the same, sometimes I may need a little reinforcement from the newer PROs.

Offline JWWebster

  • Technician
  • Member Since: Jan 2008
  • Posts: 8780
  • Country: us
  • SublimeMasterJW
    • Buy me a beer through paypal
    • JW's Sublime Appliance Advice
Re: GE Oven doesn't reach temperature (120-150 Below setting)bAKE
« Reply #3 on: May 30, 2008, 02:26:46 PM »
Call 1-877-477-7278 and tell them you need
 Part Number: AP2025110 made by GE
The part you get will probably be after market made in mexico and will not come with new wiring instructions.Give them youe model and serial number and let them verify that I have the part number correct. This is the oven control board
« Last Edit: May 30, 2008, 02:28:47 PM by JWWebster »
May the hinges of our friendship
        never grow rusty.

About the icons: The beer is tip link, if a tech saves ya some money buy em a 6 pack. The small green square=personal message. The green dot is a link to my web page on appliance repair and other general BS I love to post. The letter sends me email.
I love fan letters! LOL

Offline Earl Dryer

  • Technician
  • Member Since: May 2008
  • Posts: 166
  • Country: us
Re: GE Oven doesn't reach temperature (120-150 Below setting)bAKE
« Reply #4 on: May 30, 2008, 07:35:52 PM »
Thank you, JW for your help, I 'll my sale rep at APP and get him to fix me up. I found a site that would rebuild these no longer in production boards but couldn't locate any after market stuff.
Thanks again
Earl

PS. Just got off phone with APP Ap2025110 is no longer available.
« Last Edit: May 30, 2008, 07:45:02 PM by Earl Dryer »

Offline JWWebster

  • Technician
  • Member Since: Jan 2008
  • Posts: 8780
  • Country: us
  • SublimeMasterJW
    • Buy me a beer through paypal
    • JW's Sublime Appliance Advice
Re: GE Oven doesn't reach temperature (120-150 Below setting)bAKE
« Reply #5 on: May 30, 2008, 08:03:20 PM »
What does that tell you about GE products in particular? Makes you want to run right out and buy another electronic new fangled bunch of mess don't it?
May the hinges of our friendship
        never grow rusty.

About the icons: The beer is tip link, if a tech saves ya some money buy em a 6 pack. The small green square=personal message. The green dot is a link to my web page on appliance repair and other general BS I love to post. The letter sends me email.
I love fan letters! LOL

Offline Earl Dryer

  • Technician
  • Member Since: May 2008
  • Posts: 166
  • Country: us
Re: GE Oven doesn't reach temperature (120-150 Below setting)bAKE
« Reply #6 on: May 30, 2008, 08:28:10 PM »
You know, I think I'll spend my whole Goverment stimulus check that way :2funny:
Thanks again
Earl

Offline RegUS_PatOff

  • Technician
  • Member Since: Dec 2007
  • Posts: 1410
  • Country: us
Re: GE Oven doesn't reach temperature (120-150 Below setting)bAKE
« Reply #7 on: May 31, 2008, 04:20:27 AM »
SearsPartsDirect shows they have the Control in stock $199

http://www.searspartsdirect.com/partsdirect/retrievePartAction!search.action?productGroup=N%2FA&partNumber=WB27K5055R

but check your oven sensor again:

1100 OHMS @ room temp
2650 @ clean temp (850F ?)

2 OHMS per DEGREE F =
1650 ohms @ 350F

1950 ohms @ 500F



« Last Edit: May 31, 2008, 04:27:24 AM by RegUS_PatOff »
After leaving this Earth, "Do you want the smoking or non-smoking section?"

Offline Repair-man

  • Technician
  • Member Since: Feb 2008
  • Posts: 3020
  • Country: us
  • The Virtual Repairman
    • The Virtual Repairmans Appliance Help
Re: GE Oven doesn't reach temperature (120-150 Below setting)bAKE
« Reply #8 on: May 31, 2008, 06:40:01 AM »
It's the electronic control, for sure. The pre-heat function relies on a 60 Hz. clock timing to complete the initial preheat. When the EEPROM chip fails the clock can start to run on 50 Hz instead, causing it to prematurely reach the preset temperature on the display way before the oven has had time to catch up, heat-wise. The oven sensor does not have anything to do with this function.
"It's only expensive if someone else fixes it for you" -
The Virtual Repairman   www.repair2000.com

Offline Earl Dryer

  • Technician
  • Member Since: May 2008
  • Posts: 166
  • Country: us
Re: GE Oven doesn't reach temperature (120-150 Below setting)bAKE
« Reply #9 on: June 01, 2008, 11:11:08 AM »
Thank you all, I will check the sears site. Re-pair man can EEPROM chip be replaced to correct the problem?

Offline Repair-man

  • Technician
  • Member Since: Feb 2008
  • Posts: 3020
  • Country: us
  • The Virtual Repairman
    • The Virtual Repairmans Appliance Help
Re: Replacing the EEPROM?
« Reply #10 on: June 01, 2008, 12:13:50 PM »
I feel like DR. McCoy on Star Trek when someone asks me a question like that...

"Jim, I'm a doctor, not an electronics engineer!"   :)

I've never touched a single board to repair it for any reason in all of my 34 years of appliance repair. Some folks might be more comfortable with things like that, but that's not in my relam of expertise.     Yet.  Too many factors may have caused the chip failure, including power surge. This likely took out other components, like diodes which may be in the circuit to control power flow. Unless you are prepared to diagnose the whole board, replacing the chip alone is a gamble.
« Last Edit: June 01, 2008, 12:17:31 PM by Repair-man »
"It's only expensive if someone else fixes it for you" -
The Virtual Repairman   www.repair2000.com

Offline Earl Dryer

  • Technician
  • Member Since: May 2008
  • Posts: 166
  • Country: us
Re: GE Oven doesn't reach temperature (120-150 Below setting)bAKE
« Reply #11 on: June 01, 2008, 02:06:44 PM »
 O0 Good anwser BONES. I'll call Sears tomorrow to see if that part is in stock for real. Computer says it is (same part # with a R suffix) recon the R is for rebuilt or remanufactured?

Offline RegUS_PatOff

  • Technician
  • Member Since: Dec 2007
  • Posts: 1410
  • Country: us
Re: GE Oven doesn't reach temperature (120-150 Below setting)bAKE
« Reply #12 on: June 01, 2008, 02:31:32 PM »
... I'll call Sears tomorrow to see if that part is in stock for real. Computer says it is (same part # with a R suffix) recon the R is for rebuilt or remanufactured? ...
could be.. it's about half the price O0 of the other ones that are NLA   
After leaving this Earth, "Do you want the smoking or non-smoking section?"

 

Whirlpool oven "bake" setting doesn't light up.

Started by jaworf

Replies: 6
Views: 4417
Last post August 10, 2008, 08:33:54 AM
by jaworf
Kenmore ultra bake oven does not maintain temperature!

Started by Turtle918

Replies: 1
Views: 2942
Last post June 10, 2011, 09:24:40 AM
by JWWebster
Amana Gas oven won't reach full temp

Started by slick50

Replies: 3
Views: 3799
Last post February 01, 2008, 09:49:57 PM
by slick50
Admiral Oven turning itself off after about 15-20 sec after set to bake

Started by Redman

Replies: 1
Views: 1448
Last post December 10, 2008, 03:50:56 AM
by Repair-man
Frigidaire Oven upper element not fully heating up on bake cycle

Started by prconsulting

Replies: 2
Views: 3707
Last post December 28, 2008, 09:20:32 AM
by jumptrout51
12001656 Maytag Range Oven Temperature Sensor

Started by AJ

Replies: 0
Views: 4747
Last post March 25, 2009, 06:44:34 PM
by AJ