Author Topic: Kenmore 70 series electric dryer...wont heat  (Read 37260 times)

Offline lalakelley

  • VIP Member
  • Member Since: Feb 2008
  • Posts: 35
Re: Kenmore 70 series electric dryer...wont heat
« Reply #45 on: May 30, 2008, 05:49:53 PM »
Ok, UPDATE...My husband never tested those last things you suggested but has given up on all the test...he left to go get a new fuse and thermostat...he will be putting them in tonight so I will let you know how it works :)

Offline JWWebster

  • Technician
  • Member Since: Jan 2008
  • Posts: 8780
  • Country: us
  • SublimeMasterJW
    • Buy me a beer through paypal
    • JW's Sublime Appliance Advice
Re: Kenmore 70 series electric dryer...wont heat
« Reply #46 on: May 30, 2008, 09:47:20 PM »
#1 is likely gone bad as pictured. Luckily both 34 and number 1 come in the same package and they recommend both get replaced. Why? Because 34 is a 250f degree limit(resetable internally) and #1 is a 300f degree limit non-re-setable, Obviously the number 34 klixon failed to do it's job or more likely did it's job till it died due to poor venting problems or faulty control thermostats.
May the hinges of our friendship
        never grow rusty.

About the icons: The beer is tip link, if a tech saves ya some money buy em a 6 pack. The small green square=personal message. The green dot is a link to my web page on appliance repair and other general BS I love to post. The letter sends me email.
I love fan letters! LOL

Offline lalakelley

  • VIP Member
  • Member Since: Feb 2008
  • Posts: 35
Re: Kenmore 70 series electric dryer...wont heat
« Reply #47 on: May 31, 2008, 07:41:59 AM »
WELL...that didn't work, so today he is going to go get a new heating element, the thermal fuse and the other thermostat that is near connected into the vent housing thing. We figure this is going to work cause after that point we will have replaced almost everything on the dryer and have olmost a new dryer :)

Offline Earl Dryer

  • Technician
  • Member Since: May 2008
  • Posts: 166
  • Country: us
Re: Kenmore 70 series electric dryer...wont heat
« Reply #48 on: June 01, 2008, 03:51:24 PM »
Try this, I've had these small elements drive me crazy because they
test good but they are fused. Clip the test leads on each of they element terminals, set the OHMMeter to show a mid scale reading then gently shake the element back & forth up & down watch the
meter. I have 2 in the last month that were fused but would close back up when the cooled then open when they began to heat.

Offline lalakelley

  • VIP Member
  • Member Since: Feb 2008
  • Posts: 35
Re: Kenmore 70 series electric dryer...wont heat
« Reply #49 on: June 02, 2008, 08:28:10 AM »
UPDATE  ;D He went to Sears on Saturday, to buy the thermal fuse(which they didnt have) other thermostat(which the didnt have either) and heating element(they had this). When he got home he replaced the heating element and the dryer works GREAT. Better than when we first bought it :) Thank you though for all your help


WHIRLPOOL 279838 Whirlpool Dryer Heating Element, AP3094254



Offline AJ

  • Technician
    Administrator
  • Member Since: Jun 2007
  • Posts: 9309
  • Country: us
    • ApplianceJunk.com - Appliance Repair Help
Re: Kenmore 70 series electric dryer...wont heat
« Reply #50 on: June 02, 2008, 04:40:56 PM »
Glad to hear you got it repaired.

Thanks for the update.
Hope you find our site helpful.

Offline johnbessa

  • VIP Member
  • Member Since: Nov 2011
  • Posts: 1
Re: Kenmore 70 series electric dryer...wont heat
« Reply #51 on: November 23, 2011, 02:19:21 PM »
I see that you guys are testing with the machine on.  I had a no-heat problem (after replacing the belt) that I successfully traced using "a continuity tester" which was the OHM reader on an up-to-date (yellow w/ battery) volt meter.  I needed a helper when the wires went from the back to under the drum where the motor is.  (Drum was out.)

I strongly NOT suggest using full power for testing continuity (but OK on cars w/ 12v) esp if there is a possibility of a kid or pet touching the inner parts, but using an OHM meter.  You can make one by wiring a flashlight bulb to a battery with one wire, and to two nails from the batter and the other lead of the light bulb (which I have done many times).

John

Offline JWWebster

  • Technician
  • Member Since: Jan 2008
  • Posts: 8780
  • Country: us
  • SublimeMasterJW
    • Buy me a beer through paypal
    • JW's Sublime Appliance Advice
Re: Kenmore 70 series electric dryer...wont heat
« Reply #52 on: November 23, 2011, 04:22:04 PM »
I don't suggest ever checking anything with it plugged in. The correct procedure is to remove wires from each component and check em for continuity. The open component is the bad component. Nothing needs to be plugged in to be checked. Even if you had an idiot light and checked each component that would not prove a part was ok UNLESS you yank one wire off each component and check for power between that wire and the component with the machine running. That is just plain dumb. Trust me. Been there done that.  :rofl:
May the hinges of our friendship
        never grow rusty.

About the icons: The beer is tip link, if a tech saves ya some money buy em a 6 pack. The small green square=personal message. The green dot is a link to my web page on appliance repair and other general BS I love to post. The letter sends me email.
I love fan letters! LOL

Offline RegUS_PatOff

  • Technician
  • Member Since: Dec 2007
  • Posts: 1410
  • Country: us
Re: Kenmore 70 series electric dryer...wont heat
« Reply #53 on: November 24, 2011, 02:40:03 AM »
I usually test with voltage applied
no need to disconnect anything
i.e. Electric Dryer Heater circuit...
voltage here... voltage here... voltage here... voltage here... oops .. no voltage here. . !
After leaving this Earth, "Do you want the smoking or non-smoking section?"

Follow us on Google+
 

Kenmore 70 Series Electric dryer wont heat up

Started by Paco taco

Replies: 4
Views: 6888
Last post December 29, 2009, 11:32:31 AM
by whirlpooltech
Kenmore 70 Series Electric dryer wont heat up

Started by kid_sketch

Replies: 22
Views: 7285
Last post January 21, 2010, 09:36:42 PM
by AJ
70 series Kenmore electric dryer spins but does not heat

Started by llew_x

Replies: 52
Views: 42239
Last post July 23, 2013, 08:25:04 AM
by JWWebster
Kenmore 70 series electric dryer no heat again

Started by weadhopper

Replies: 5
Views: 4636
Last post May 14, 2009, 11:13:08 PM
by JWWebster
Kenmore 70 series electric dryer no heat again

Started by connie

Replies: 10
Views: 3723
Last post June 09, 2009, 05:59:07 AM
by connie
Kenmore 80 Series Electric Dryer won't heat

Started by snottrocket

Replies: 8
Views: 14049
Last post June 06, 2011, 09:35:10 PM
by JWWebster