Author Topic: ge built in refer m#zisb420drj diagnostics  (Read 981 times)

Offline grkeener

  • Technician
  • Member Since: Apr 2011
  • Posts: 42
  • Country: us
  • 45 years of appliance repair's
ge built in refer m#zisb420drj diagnostics
« on: May 02, 2013, 09:04:15 AM »
anyone know the well keeped secrets to enter and exit the self diagnostics? for a ge monagram #zisb420drj refrigerator
bk1953

Offline apu

  • Technician
  • Member Since: Apr 2011
  • Posts: 69
  • Country: us
Re: ge built in refer m#zisb420drj diagnostics
« Reply #1 on: May 02, 2013, 09:43:13 PM »
 
 Not exact model # !
 
 
   Jim
 
 

Offline AJ

  • Technician
    Administrator
  • Member Since: Jun 2007
  • Posts: 9371
  • Country: us
    • ApplianceJunk.com - Appliance Repair
Re: ge built in refer m#zisb420drj diagnostics
« Reply #2 on: May 02, 2013, 10:03:40 PM »
Here you go...(also from Jim, thanks!)

http://appliancejunk.com/forums/index.php?topic=12053.0
Hope you find our site helpful.

Offline AJ

  • Technician
    Administrator
  • Member Since: Jun 2007
  • Posts: 9371
  • Country: us
    • ApplianceJunk.com - Appliance Repair
Re: ge built in refer m#zisb420drj diagnostics
« Reply #3 on: May 03, 2013, 07:17:38 AM »
From page 61 of the service manual...

Quote
Enter the diagnostic mode by pressing both the freezer temperature pads (plus and minus) and the refrigerator temperature pads (plus and minus) simultaneously. All 4 pads must be held for approximately 3 seconds. A blinking 0 in both displays indicate the refrigerator has entered the test mode.

I have attached the two page from the service manual that cover, "Diagnostic Mode".

Hope that helps.

Care to share with us what's wrong with it?
Hope you find our site helpful.

Offline grkeener

  • Technician
  • Member Since: Apr 2011
  • Posts: 42
  • Country: us
  • 45 years of appliance repair's
Re: ge built in refer m#zisb420drj diagnostics
« Reply #4 on: May 03, 2013, 07:23:42 AM »
yes i think it will help alot   thank you very much
bk1953

Offline grkeener

  • Technician
  • Member Since: Apr 2011
  • Posts: 42
  • Country: us
  • 45 years of appliance repair's
Re: ge built in refer m#zisb420drj diagnostics
« Reply #5 on: May 03, 2013, 07:32:00 AM »
it was not cooling in ff side and i tried to enter diagnostics but had wrong codes and was stuck in show room mode i think. it will only flash off and beep when i push buttons it will not respond at all ! i have unplugged unit and replugged but same results. now i have the right codes and test manual [thanks to you] i will find out what is going on
                                                                                                              thank you again i will post what i found
bk1953

Offline AJ

  • Technician
    Administrator
  • Member Since: Jun 2007
  • Posts: 9371
  • Country: us
    • ApplianceJunk.com - Appliance Repair
Re: ge built in refer m#zisb420drj diagnostics
« Reply #6 on: May 03, 2013, 07:38:15 AM »
Quote
i will post what i found

Sounds great, looking forward to the update.  O0
Hope you find our site helpful.

 

Video: How to make your Whirlpool ice maker run for testing and diagnostics

Started by AJ

Replies: 10
Views: 42145
Last post April 16, 2013, 10:40:23 PM
by charlenemhj
Kitchenaid Built-in Refrigerator DOA

Started by TechnicianBrian

Replies: 0
Views: 1937
Last post August 07, 2008, 08:37:17 PM
by TechnicianBrian
GE Refrigerator Self Diagnostics

Started by barberofcivil

Replies: 14
Views: 22950
Last post December 13, 2009, 08:41:57 PM
by JWWebster
GE side by side refer clicking not cooling

Started by psj12

Replies: 4
Views: 1770
Last post May 28, 2009, 11:53:00 AM
by whirlpooltech
Viking Range Corporation Recalls Built-In Refrigerators

Started by AJ

Replies: 0
Views: 1484
Last post June 16, 2009, 12:31:37 PM
by AJ
KAR-17 KitchenAid Built-In French Door Bottom Mount Refrigerator Service Manual

Started by AJ

Replies: 0
Views: 1685
Last post August 20, 2009, 01:04:31 PM
by AJ