I worked on a fridgidaire refrigerator model #FRS26R2A, the compressor was kicking on and off. So I replaced the relay plug kit, the problem didn't go away. Then after about two hours of checking and rechecking then staring at the diagram, I realized that the overload was probably open as it was a temp controlled. Then I plugged the fridge back in, at this point it was unplugged for about 20 minutes then when I plugged it in the compressor came on and cooled the unit down to 20 degrees. Then about two hours later the customer said it wasn't cooling again. So I told him to leave it unplugged for about 2 hours and that should let the overload cool down completely. Other than that I think it needs a ADC (control board) what do y'all think?