Author Topic: Code 62 from LEQ1442ES1 Electrolux Dryer (No help from manufacture)  (Read 540 times)

Offline eddie27970

  • VIP Member
  • Member Since: Nov 2013
  • Posts: 1
Hello everyone.  I have an Electrolux Dryer in a rental house, that I noticed was randomly blinking LEDs and beeping.  Naturally, I pulled the lint screen and was shocked to see the cavity below it was almost completely stopped up!  I took the dryer apart and cleaned everything.  When I put it all back together, it still blinked and beeped.  Since then, I found the procedure for Codes and Run Tests.  There's no doubt it is giving a Code 62, which I cannot find online,  :'(.  I sent message to Electrolux and they answered....

"The 62 code means that the control panel has detected a heat relay failure."

They went on to suggest I contact an Authorized Service Provider.  (Isn't that what I'm doing posting here?)  I've done maintenance work all my life and have 8 years of Electronics in the military.   When I did the Run Tests, I could not make heads or tails of the Thermistor Temperature blinking LEDs.  I used my Temp Gun and got about 150-degrees in the Drum.  Is this about right?  This Heat Relay is mounted on the Control Board.  I'd hate to spend the $130, or so, only to still get a Code 62.  Any help greatly appreciated.   :thanks:

 

Whirlpool Steam Dryer F23 Error Code

Started by TechnicianBrian

Replies: 2
Views: 6127
Last post April 25, 2008, 08:25:02 PM
by TechnicianBrian
Error code 40 on Oasis Elite Dryer

Started by MWCmike

Replies: 3
Views: 4132
Last post September 16, 2008, 03:36:21 PM
by Repair-man
Electric Dryer LEQ2152ES0 not heating error code e56

Started by DeeStough

Replies: 11
Views: 10057
Last post February 23, 2011, 12:06:45 AM
by AJ
WTE-86300US FAULT CODE FOR BOSCH VENTLESS DRYER

Started by MP

Replies: 0
Views: 3021
Last post November 20, 2008, 04:15:42 PM
by MP
Frigidaire Front Load Dryer Error Code DR

Started by sharitac

Replies: 6
Views: 15004
Last post April 26, 2009, 09:07:40 AM
by JWWebster
GE Electric dryer with digital readout shows IH fault code

Started by Washaman

Replies: 0
Views: 2977
Last post October 26, 2009, 11:52:56 PM
by Washaman