Author Topic: MAH4000 operating modes  (Read 503 times)

Online def

  • VIP Member
  • Member Since: Feb 2013
  • Posts: 94
  • Country: us
  • I'll fix anything...sometimes, I'm successful.
MAH4000 operating modes
« on: April 30, 2013, 01:33:18 AM »
So, my resurrected Maytag Neptune has been working fine since I installed a rebuilt control board.

However, today, I noticed that it added bleach near the end of the wash cycle. Then, it added bleach again during the rinse cycle. Finally, it correctly added softener at the last rinse cycle.

I'm stumped by the first bleach addition before the wash cycle completed. Is this the correct operation or does my Neptune need more brain surgery?  :thinking:
I used to repair RADAR then they discontinued vacuum tubes. Pity

Offline sparky823

  • VIP Member
  • Member Since: Sep 2007
  • Posts: 132
Re: MAH4000 operating modes
« Reply #1 on: April 30, 2013, 01:56:12 AM »
I have one just like yours and it is operating normally. It puts the bleach in the last 2 minutes of the wash cycle. Then when it fills for the 1st rinse it runs water into the bleach cup again to make sure it is all flushed out. Then softener goes in during 3rd rinse even if you select extra rinse(4th on dial). Everything working as should.

Online def

  • VIP Member
  • Member Since: Feb 2013
  • Posts: 94
  • Country: us
  • I'll fix anything...sometimes, I'm successful.
Re: MAH4000 operating modes
« Reply #2 on: April 30, 2013, 02:02:49 AM »
I have one just like yours and it is operating normally. It puts the bleach in the last 2 minutes of the wash cycle. Then when it fills for the 1st rinse it runs water into the bleach cup again to make sure it is all flushed out. Then softener goes in during 3rd rinse even if you select extra rinse(4th on dial). Everything working as should.

 :thanks: sparky823

 O0
I used to repair RADAR then they discontinued vacuum tubes. Pity

 

Maytag Neptune MAH4000 door lock all the time

Started by tigerchuong

Replies: 5
Views: 3796
Last post September 18, 2008, 08:23:00 PM
by whirlpooltech
Neptune MAH4000 over filling

Started by bstrawn

Replies: 5
Views: 1260
Last post September 10, 2012, 09:47:17 PM
by andersenappliance
Maytag MAH4000 does not go into Rinse-Cycle Intermittent-Issue

Started by granaudio

Replies: 4
Views: 4994
Last post April 22, 2009, 10:36:19 PM
by granaudio
Maytag Neptune mah4000 fills then stops

Started by nimu23

Replies: 16
Views: 2299
Last post November 06, 2012, 09:25:37 AM
by nimu23
Maytag Neptune washer MAH4000 leaking and cleaning

Started by flyshooter

Replies: 9
Views: 774
Last post October 02, 2013, 08:41:39 PM
by flyshooter
MAH4000 thumping and banging

Started by def

Replies: 2
Views: 319
Last post September 30, 2013, 10:08:26 PM
by def