Figure this one out. Left machine week ago inoperative. Posted up. Went back armed with motor, capacitor, temperature switch. Expecting bad motor plugged machine in opened water valves, set water level switch to medium. Tub filled, meter set to closed agitate switch read 123vac on fill side. Put leads on full side, reading low voltage. Filling shuts off, Voltage jumps to 123vac on full side & machine agitates. Set timer to spin cycle, washer drains & begins spinning after tub drains partially.
Had dead washer week ago, fill only difference I see is that hot water side was closed do to customer replacing water heater. Did not think that mattered last week when filling unit with cold setting.
Spent some time there washing several loads of clothes, Machine works great. I have checked wiring & spade terminals for corrosion, A problem in this gulf coast air. I could not discern any thing out of ordinary. Unit is working like new all cycles, temp switch working all 4 settings, extra rinse working all settings. The Gods of wash playing with me? or the customer, a Jehovah Witness.