Washer PartsDryer PartsRefrigerator PartsDishwasher PartsRange & Oven PartsAll Appliance Parts

Author Topic: Kenmore Washer Not Spinning  (Read 2671 times)

Offline TechnicianBrian

  • Technician
  • Member Since: Dec 2007
  • Posts: 390
  • Country: us
    • TechnicianBrian.com
Kenmore Washer Not Spinning
« on: May 18, 2008, 07:42:18 AM »

Model #110.20992991, this washer operated fine until it reached the spin cycle where it would drain, but the basket would not spin. Thinking it had a clutch problem, I rotated the timer to begin a spin cycle, and then tried to spin the basket by hand to give it a little help. If you can spin the basket by hand both ways, this is a sure sign of a bad clutch, but this one took off spinning and started making a thumping noise that sounded like something was stuck between the basket and the tub. After removing the tub ring, I found the fill hose from the valve assembly (this unit has five valves) had broken off and somehow made its way into the tub and prevented the basket from spinning. After removing the hose, the unit started spinning great and after replacing the tub ring (the hose comes with the entire ring) this washer now works again.

« Last Edit: May 18, 2008, 07:57:34 AM by AJ »


Kenmore Washer Not Spinning Properly

Started by TechnicianBrian

Replies: 0
Views: 3979
Last post April 23, 2008, 10:10:20 PM
by TechnicianBrian
one more "kenmore washer not spinning" thread

Started by idave03

Replies: 3
Views: 4186
Last post May 12, 2008, 03:11:05 PM
by idave03

Started by y_ebbi

Replies: 16
Views: 10764
Last post October 23, 2008, 08:17:22 PM
by Al Capone
kenmore 70 series washer not spinning

Started by snault80

Replies: 5
Views: 15500
Last post December 08, 2008, 05:50:35 PM
by Repair-man
Kenmore Front Loader Washer Making Noise but Drum not spinning

Started by Jaytag

Replies: 2
Views: 3883
Last post June 22, 2009, 09:32:42 PM
by RegUS_PatOff
Kenmore Elite Washer Not Spinning at Full Speed

Started by Jaytag

Replies: 12
Views: 6139
Last post May 14, 2010, 05:47:47 PM
by jumptrout51