Author Topic: MAH4000AWW spin issues  (Read 795 times)

Online RAH52

  • Technician
  • Member Since: Aug 2008
  • Posts: 701
  • Country: ca
MAH4000AWW spin issues
« on: April 03, 2013, 05:06:28 PM »
This one puzzels me .The washer works fine except in the spin cycle after about 1 minute the washer shuts down ,lock lite stays on push power and it spins again ...does reach high speed.It will do this 2 or 3 times during the spin .Any ideas ?

Offline Bailey

  • Technician
  • Member Since: Dec 2011
  • Posts: 651
  • Country: us
Re: MAH4000AWW spin issues
« Reply #1 on: April 03, 2013, 09:50:40 PM »
Use a jumper and bypass the out of balance circuit. See what happens.

Offline BJL

  • VIP Member
  • Member Since: Jul 2013
  • Posts: 3
Re: MAH4000AWW spin issues
« Reply #2 on: July 15, 2013, 10:20:41 AM »
Where can I find the out of balance circuit to jump? Thanks much.

 

Maytag Neptune MAH4000AWW - No Spin.

Started by larry

Replies: 39
Views: 61396
Last post February 21, 2011, 01:22:14 PM
by bwhelan
Maytag washer mah4000aww spin cycle

Started by evo100

Replies: 1
Views: 3292
Last post December 25, 2007, 09:41:02 PM
by AJ
Maytag Neptune Mah4000aww will not go through cycles or spin...

Started by Mudd222

Replies: 11
Views: 5239
Last post April 23, 2013, 11:14:30 AM
by def
Maytag Neptune MAH4000AWW burning smell during spin cycle.

Started by ksujason

Replies: 15
Views: 18623
Last post September 14, 2008, 11:46:31 PM
by Repair-man
Neptune MAH4000AWW - No Spin/Contoller board not burnt

Started by geohec

Replies: 5
Views: 5269
Last post January 10, 2009, 04:12:48 PM
by geohec
whirlpool washer final spin issues

Started by streetrodmaniac

Replies: 6
Views: 3653
Last post January 12, 2009, 08:15:52 AM
by streetrodmaniac