Forum > Range, Oven & Cooktop Repair

GE Microwave JVM1850WH05 Shutting off

(1/2) > >>

Preferred Appliance:
On my first visit, I found the fan blade off the fan motor that cools the Mag.Installed new fan motor and secured fan blade.  Reasembled MW and tested it. It tested ok. I went back because now it cuts off after running it for 6 minutes as opposed to two minutes on first trip. Upon inspection I found fan and motor intact however doesnt seem to spin as fast as I think it should when in use. Has anyone come across this?

Preferred Appliance:
yeaaaah, me neither. hahahaha

JWWebster:
Make sure the holes drilled in the wall beside the mag are not plugged with grease. that will cause the mag to overheat and trip the switch after 6 minutes.

Bailey:
Did you install wb26x10089 fan motor?

Preferred Appliance:
Sure did.

Navigation

[0] Message Index

[#] Next page

Go to full version