Forum > Washer Repair

cabrio washer

(1/2) > >>

wpearson:
I have a cabrio washer Model# wtw6500ww that will start and just stop.I unplug lid switch but back in ran one load, then stop run again,I am thank the lid switch are the machine /motor control. have any one ran in to the problem.

Thank,






niobrara:
Does it throw any error code ? Did you run diagnostics ?

haroldsappliance:
Remove all quick disconnects from board for a couple minutes then reinstall. There's been a few times where I thought the board was bad and done this procedure and it worked.

wpearson:
Hi guys,
I ran a diagnostics remove all connects,it gave me a F51 code which is the RPS rotor postition sensor. will try this tomorrow will let everyone know if this work.Think to Technician Brian for your advice.

schleven:
Isnt that one of those that was being fixed free by whirlpool under a recall?

Navigation

[0] Message Index

[#] Next page

Go to full version