If you have object between tubs could that cause unbalance load? Did you check that?
I really like there washers. And have not had a lot of problems with them,but now have 3 that keep unbalancing. Looking at the records on them about everything has been replaced,a couple of at least twice.Software was updated also. So I'm trying a clutch on one. One I really think is customer issue. But that still leaves the other two.And yes they all spin. Thanks, hopefully Wild or John can share some information.
What about worn suspension rods? How is the tub suspended? Never even seen an LG top loader. Most of these machines nowadays have rods holding the tub. Some have lateral straps. Have no idea what an LG top loader looks likes.
Well if they are new machines then thats an easy one. BoBo install. The legs were not properly leveled most likely.
Try this...Make 2 marks with a sharpie---one on the STATOR---and another on the TUB.Now remove the STATOR and re-install in a different position.Test washer in spin (empty tub).Re-position the STATOR several times---if needed---until the washer spins without imbalance (or triggers an error).
Started by HORN 34
Started by skraw
Started by newbie123
Started by DWEST
Started by JWWebster
Started by resapp