My washer is less than 1.5 Years Old and the display shows UE
(Out of Balance
) during Spin mode
). The Basket moves freely both direction's, Legs are level and the Support/Suspension Rod's look fine. I checked the Sensor Assembly
located in lower rear corner by Drain Pump) with Multimeter and it has NO Continuity
(the wire harness has continuity). I looked inside the Cabinet for a Tech Sheet to assist me but it wasn't there
. Therefore, would the part mentioned above cause the UE error code? If not,
do you have a Service Manual or can you tell me how to run a Diagnostic Test.