Author Topic: Micro. no power after bulb put in and spark's flew  (Read 1420 times)

Offline domain

  • Technician
  • Member Since: Nov 2012
  • Posts: 1078
  • Country: us
Re: Micro. no power after bulb put in and spark's flew
« Reply #10 on: February 11, 2013, 04:50:08 PM »
Small pcb is your line noise filter that is also fused. Check for 120vac in and 120vac out. If you have 120 vac out, your filter pcb is good. If 120vac is at your main pcb, and control is dead, there lies your problem. You have 3 thermal fuses on this unit unless I'm mistaken. One is for magnatron (Normally closed). One is for oven cavity (Normally closed). The last should be for the stove top (Normally Open). Hope this helps. :D

Offline Bailey

  • Technician
  • Member Since: Dec 2011
  • Posts: 662
  • Country: us
Re: Micro. no power after bulb put in and spark's flew
« Reply #11 on: February 12, 2013, 10:15:00 AM »
On some microwaves the wiring diagram is behind the grill.

 

Spark Lid-top Range

Started by darnoldy

Replies: 4
Views: 5076
Last post January 23, 2008, 11:19:00 AM
by darnoldy
Frigidaire Microwave No Power

Started by TechnicianBrian

Replies: 0
Views: 3499
Last post April 15, 2008, 09:57:53 PM
by TechnicianBrian
GE Microwave Loses Power

Started by sapp4l

Replies: 6
Views: 5553
Last post June 02, 2008, 10:39:00 PM
by sapp4l
power on but DOES NOT WORK

Started by dangosborn1

Replies: 7
Views: 2620
Last post July 27, 2008, 08:41:07 PM
by JWWebster
Whirlpool Wall oven/Micro

Started by service1

Replies: 4
Views: 4992
Last post September 24, 2008, 07:53:12 AM
by whirlpooltech
GE Oven will not power up.

Started by TempeRentals

Replies: 2
Views: 1490
Last post December 04, 2008, 01:39:01 AM
by TempeRentals