I hate hidden bake elements. Went out on this stove to install an element the customer had purchased. Easy call right? First off I couldn't find where the element was. Sitting there scratching my head I finally got the brilliant idea to look for a tech sheet. Turns out you have to lift the top and remove the left side panel. Even following the directions I had a hard time finding a screw that is inside the left front leg. Finally, there is the ends of the element. One more piece of sheet metal to remove and the element will slide out. Not so fast. The element had shorted out and welded itself to the bottom of the oven.The slot that the element slides in to is about 1" tall and the stuck part was just barely out of reach of my longest screwdriver. Told the customer what was going on and she let me rummage through her husbands garage. Found a piece of flat steel and used it and a hammer to dislodge the stuck section. Cmon, do people care if the element is in sight or not? This is just a marketing ploy.