Forum > Washer Repair

Maytag mah4000aww service manual

<< < (4/5) > >>

Windwood:
Here's my motor control board.  It looks different than what's in the manual.

http://www.windwoodllc.com/images/Maytag/SAM_0072.jpg

AJ:

--- Quote ---Here's my motor control board.  It looks different than what's in the manual.
--- End quote ---

They have made changes to the motor control board since the manual was made.


--- Quote ---Power is at the motor control board, delay light is on.
--- End quote ---

I would pull the motor control board out of the plastic case and look it over for damaged components and burnt paths.

Think it's been about a year or so since I have worked on a MAH4000 so I maybe a little rusty on them now. Just don't see them around much any more with all the problems they have had in the past.

Is that the original motor control board in your washer now or had it been replaced before?

Windwood:
Thanks, AJ.  I'll pull it tomorrow and have a look.

Don't know if it's the original.  I do recall a 500.00 repair about 8 years ago, but can't recall what it was all about.  I might be able to convince the wife to hunt up the receipt, but won't hold my breath on finding it.

tgoods:
That's the newer updated motor control.

joestehling:
How can I get a service manual?    My R-11 resistor is burnt but I do not know how to access the wax motor.

Navigation

[0] Message Index

[#] Next page

[*] Previous page

Go to full version