MODEL MVWX700XW SHIFTER WIRE HARNESS

[gregaguilar]

 I DIAGNOSED WASHER SHIFTER TO BE OUT AND WHEN I WENT TOO REPLACE IT WITH A NEW ONE FOUND WIRE HARNESS HAD TWO WIRED BROKEN  QUESTION IS  IS THERE ANY WAY TO REPAIR THIS END OF HARNESS WITHOUT HAVING TO BUY THE WHOLE HARNESS.?

[tgoods]

Where did it break, at the molex plug?  You can pop the terminal out of the plug, solder the wire to it and snap it back in.  I did that with broken wire on the motor capacitor on one of these.  It was a snap together plug so it was easy to get the terminal out.  Make sure you have good strain relief on the wires so it doesn't break again.