Author Topic: MayTag A21CS Fills but won't start  (Read 455 times)

Offline KenW

  • VIP Member
  • Member Since: Dec 2012
  • Posts: 6
  • Country: ca
MayTag A21CS Fills but won't start
« on: January 04, 2013, 11:45:53 PM »
I have a Maytag A21CS that fills with water but does not start into the cleaning cycle.  The lid switch works fine because if I lift the lid while the tub is filling the machine stops.  However once the tub is full the machine just sits there with the clean light on.  Is is the timer?

Offline jumptrout51

  • Technician
  • Member Since: Nov 2007
  • Posts: 1879
  • Country: us
    • Buy me a beer through paypal
Re: MayTag A21CS Fills but won't start
« Reply #1 on: January 05, 2013, 08:17:55 AM »
If set to spin, will the machine spin?
If it spins,the water level switch may be sticking and not sending power back through the timer to agitate.
Take a Kid fishing.

Offline KenW

  • VIP Member
  • Member Since: Dec 2012
  • Posts: 6
  • Country: ca
Re: MayTag A21CS Fills but won't start
« Reply #2 on: January 06, 2013, 09:54:18 PM »
The machine will not do anything on any cycle.  I suspect timer motor at this point.

 

Maytag washer model LAT3500AAE fills w/water,shuts off, won't start again

Started by 3rdwasherfromcl

Replies: 5
Views: 642
Last post June 16, 2013, 08:28:09 PM
by 3rdwasherfromcl
Maytag Atlantis Model (MAV9501EWW) Will Not Start

Started by mngambas

Replies: 8
Views: 4948
Last post November 01, 2007, 11:42:28 AM
by mngambas
Maytag Washer - Fills with water, then does nothing...

Started by AJ

Replies: 7
Views: 7842
Last post February 21, 2008, 05:34:00 PM
by AJ
Washer Issue - Runs, Fills, Start Wash...Loud Grinding for 60s, Drain, Spin Done

Started by Moose101

Replies: 16
Views: 5552
Last post April 30, 2008, 05:39:30 PM
by AJ
help with maytag neptune front load washer start but stop after few seconds..

Started by soccerboy

Replies: 4
Views: 4055
Last post August 06, 2008, 06:40:10 AM
by Repair-man
Maytag Atlantis Washer, fills starts stops

Started by crazeddad

Replies: 10
Views: 4533
Last post August 17, 2008, 09:57:54 AM
by Repair-man