Forum > Dryer Repair
LG DLEX2501 Powers up but turns off when the start button is pressed
domain:
There is not much else after MAIN PCB replacement.... Hopefully John or Wild will chime in with some more insightful info as I have never ran into a similar issue. :D
john63:
<<<I have replaced the control board and the display board>>>
*****************
Post the part numbers of both parts---to verify that they are correct (hopefully not purchased on EBay)
wildimaginations:
Sounds like you have a voltage problem at the plug or outlet. When you hit the start button, the amps load up to around 18 amps and that there is a slight break in the outlet that's enough to open up one side of the circuit and shut down the dryer. You'll need a volt meter to see this happen. Have an electrician check this.
bjmaxfield:
The display board part number is EBR36858901
Controll board # EBR368588
I got both boards from Repair clinic.
john63:
The *correct* part numbers are:
MAIN BOARD: EBR36858809
DISPLAY BOARD: EBR36858902
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version