Get Answers to your Appliance Repair Questions

Author Topic: GSS25sgmc bs / Dispenser area sweats, frost buildup between ice maker & door  (Read 5273 times)

Offline scrapiron

  • Technician
  • Member Since: Nov 2011
  • Posts: 366
  • Country: us
  • Service Tech Since 1974
Rusty or stripped screws? I carry a set of screw removers. They work pretty well on most all kinds of screws.

Offline plumbstar

  • VIP Member
  • Member Since: Dec 2012
  • Posts: 7
Screw remover looks interesting. I could use it anyway. Thanks!

The only reason i mentioned replacing the control board, is that many part suppliers say you have to replace when replacing the moisture kit.
Is the heater controlled by the control board or is it on all the time? Maybe a timer or thermostat on the board? If it's a higher wattage heater, the timing might be different. I think i read somewhere that the original heater is 3 watts & the replacement is 10 watts

Offline plumbstar

  • VIP Member
  • Member Since: Dec 2012
  • Posts: 7
Has anyone ever installed the moisture kit?

Offline plumbstar

  • VIP Member
  • Member Since: Dec 2012
  • Posts: 7
Here's a pict.
« Last Edit: December 09, 2012, 02:34:17 PM by plumbstar »


Ice/Water Buildup under Deli Tray (Samsung French Door with Ice/Water Dispenser)

Started by Jando

Replies: 4
Views: 319
Last post March 25, 2017, 07:02:21 AM
by AJ
Video: Whirlpool In-Door Ice Maker Fill Cycle

Started by AJ

Replies: 3
Views: 13690
Last post September 23, 2008, 05:37:19 PM
by Al Capone
No water from dispenser-ice maker working-replaced valve inlet

Started by Evan

Replies: 2
Views: 7036
Last post August 18, 2007, 05:17:53 PM
by Evan
Door on ice dispenser will not close

Started by dunenuf

Replies: 2
Views: 3514
Last post June 21, 2008, 01:26:31 PM
by JWWebster
Whirlpool F/F in door ice maker "clacking" noises

Started by Dave Walsh

Replies: 9
Views: 8065
Last post July 09, 2008, 06:43:21 AM
by Repair-man
How to replacing water line in freezer door for Ice maker?

Started by jet713

Replies: 2
Views: 8023
Last post August 21, 2008, 10:33:33 PM
by BrntToast