365-Day Hassle Free Return Policy!  ·  AppliancePartsPros.com
Washer PartsDryer PartsRefrigerator PartsDishwasher PartsRange & Oven PartsAll Appliance Parts

Author Topic: Simple Spider Question - TROMM  (Read 3505 times)

Offline FTCABill

  • VIP Member
  • Member Since: Dec 2012
  • Posts: 1
Re: Simple Spider Question - TROMM
« Reply #10 on: December 09, 2012, 03:47:37 PM »
I had the same problem with the bolt in the spider assembly just spinning and not being able to remove the Lifter Assembly bottom to get access to the nut.  I drilled out the bolt from the cap end.  You could also cut the top off the bolt.  The Lifter Assembly then slid off.  It turns out that the nut was enclosed in a plastic retainer that wore to allow the nut to spin.  There is a metal plate so you cannot just pull the Lifter Assembly off without removing the two bolts through the spider.  In reassembly, I will use a new nut and bolt.  I will have to use glue to keep the replacement nut from spinning.

 

Help Tromm washing machine wont spin

Started by angeleyes

Replies: 15
Views: 25284
Last post February 13, 2008, 08:19:59 PM
by JWWebster
LG TROMM spin fail

Started by Jos

Replies: 2
Views: 4615
Last post February 20, 2008, 10:39:37 PM
by AJ
lg tromm spin issue

Started by Jos

Replies: 3
Views: 5916
Last post February 22, 2008, 10:53:16 AM
by RegUS_PatOff
LG TROMM WASHER DRYER COMBO

Started by cammy

Replies: 1
Views: 4816
Last post March 06, 2008, 07:46:35 PM
by JWWebster
whirlpool washer coupler repair question

Started by acbclberbjcb

Replies: 1
Views: 2672
Last post October 24, 2008, 06:40:18 PM
by Repair-man
Maytag Atlantis washer bearing and seal question

Started by grdnhappy

Replies: 1
Views: 4591
Last post November 10, 2008, 01:00:32 PM
by JWWebster