Author Topic: Maytag Neptune mah4000 fills then stops  (Read 3512 times)

Offline nimu23

  • VIP Member
  • Member Since: Oct 2012
  • Posts: 10
Re: Maytag Neptune mah4000 fills then stops
« Reply #15 on: November 05, 2012, 07:54:48 PM »
Sorry but I'm don't know what to check on the motor control board.
I know how to measure resistance with my multimeter, but what should I be checking, and what readings should I be getting for each of those checks

Offline nimu23

  • VIP Member
  • Member Since: Oct 2012
  • Posts: 10
Re: Maytag Neptune mah4000 fills then stops
« Reply #16 on: November 06, 2012, 09:25:37 AM »
I tested the motor resistance across orange/yellow wires, white/red wires, and blue/black wires. All three showed between 2.1 and 2.3 ohms. The service manual says they should all be between 2 and 3 ohms so that test was passed. I also checked that each one of those wires has no continuity with the motor frame. There was no continuity.

In you last reply, you asked to "ohm out" the motor control board. Can you tell me how this is done and what I should be looking for. Thanks.

 

Maytag Atlantis Washer, fills starts stops

Started by crazeddad

Replies: 10
Views: 6035
Last post August 17, 2008, 09:57:54 AM
by Repair-man
Maytag Neptune MAH4000 door lock all the time

Started by tigerchuong

Replies: 5
Views: 4611
Last post September 18, 2008, 08:23:00 PM
by whirlpooltech
Maytag Neptune Fills then nothing

Started by ddavis263

Replies: 4
Views: 1581
Last post August 08, 2010, 02:50:19 PM
by ddavis263
Maytag Neptune front load washer continuously fills when not running

Started by clarkylm

Replies: 2
Views: 841
Last post September 06, 2013, 06:22:55 PM
by clarkylm
Maytag Neptune washer MAH4000 leaking and cleaning

Started by flyshooter

Replies: 9
Views: 1419
Last post October 02, 2013, 08:41:39 PM
by flyshooter
Maytag Neptune fills, starts to rotate and shuts off

Started by Elaine205

Replies: 7
Views: 855
Last post January 09, 2014, 07:27:44 PM
by airbendr