Author Topic: maytag front load washer MHWE450WW01  (Read 1547 times)

Offline jopale

  • VIP Member
  • Member Since: Oct 2012
  • Posts: 3
maytag front load washer MHWE450WW01
« on: October 07, 2012, 12:22:16 AM »
Control light comes on, dings 3 times and turns off, door open and unable to close it.  Someone wrote it was the user interface.. or part 6. on the diagram..   Unable to run diagnostics on it. Not sure which control panel has the pins in it to test for continuity when electrician comes between 1 to 3 for the door lock and the other 3 for the motor.. If those are ok and switches all facing upwards?? figure it's a communication problem. .and it needs a CCU.. this machine has 9 CONSOLES on its order page and three different control boards two called electronic circuits. Not sure if I should order the door latch kit etc. and try to get the door closed to see if I can start the diagnostics.. or since the CCU works both the door ,etc. or it could even be the wiring harness I suppose. Where do you start? ??

Offline AJ

  • Technician
    Administrator
  • Member Since: Jun 2007
  • Posts: 9430
  • Country: us
    • ApplianceJunk.com - Appliance Repair
Re: maytag front load washer MHWE450WW01
« Reply #1 on: October 14, 2012, 09:05:35 AM »
Did you get this fixed or do you still need help?
Hope you find our site helpful.

Offline ScottyMo1

  • Technician
  • Member Since: Nov 2011
  • Posts: 169
Re: maytag front load washer MHWE450WW01
« Reply #2 on: October 15, 2012, 12:22:25 PM »
A bad motor control board will cause that problem on those models...

Offline jopale

  • VIP Member
  • Member Since: Oct 2012
  • Posts: 3
Re: maytag front load washer MHWE450WW01
« Reply #3 on: December 02, 2012, 02:48:56 PM »
Hi, sorry I haven't been online.. nope not fixed yet... We bought the electronic board or 13 W10326989 Microcomputer,
Machine Control

I think I read somewhere, if the machine was stuck in a cycle.. and the door was closed, my son opened it.. and now we can't get door to close. .that maybe replace the door latch.. for about $60... +.. can return it I guess if it's a no go.. get a beep after plugging that part in.. and the old one did look like there were some burn marks.
Can't call out the guru's just yet.. still no job!
Thanks

Offline jopale

  • VIP Member
  • Member Since: Oct 2012
  • Posts: 3
Re: maytag front load washer MHWE450WW01
« Reply #4 on: December 02, 2012, 02:51:26 PM »
we tried this part first 6 W10283493 User Interface one light comes on, makes a beeping noise?

 

16007803 Maytag Front Load Washer Service Repair Manual

Started by AJ

Replies: 0
Views: 4767
Last post March 27, 2008, 08:23:12 PM
by AJ
16025909 Maytag MAH9700AW 27" Front Load Washer Service Repair Manual

Started by AJ

Replies: 0
Views: 6639
Last post June 03, 2008, 07:37:03 AM
by AJ
help with maytag neptune front load washer start but stop after few seconds..

Started by soccerboy

Replies: 4
Views: 5833
Last post August 06, 2008, 06:40:10 AM
by Repair-man
12002533 Maytag Front Load Washer Door Boot

Started by AJ

Replies: 0
Views: 3676
Last post April 03, 2009, 08:01:32 PM
by AJ
W10181639 Maytag Front Load Washer Support

Started by AJ

Replies: 0
Views: 3447
Last post April 03, 2009, 08:07:58 PM
by AJ
Maytag Front load Washer

Started by service1

Replies: 3
Views: 1611
Last post April 07, 2009, 08:24:34 AM
by Repair-man