white knit shirts look like burn marks after dryer ?

[cvcman]

we have a Kenmore stakable small apt sized washer dryer. Lately we have noticed what looks like burn stains kinda brown color on our white knit running shirts...they are the wicking material type.. It never shows on any other clothes...We only dry on the low heat setting..ideas ?? thank you

[tgoods]

Model number?

[cvcman]

opps sorry, model 110.98575100

Thanks

[Bailey]

Are they blotchy or streaked?

[cvcman]

streaked, looks like a fine line brown marker

[tgoods]

Replace the rear drum seal and probably the drum rollers, too.

279735

349241T

[cvcman]

great thanks so much...now one more thing...This is in a closet and  have access to the front, can I do this wthout taking it out of the closet ?? Its a pan in the rear to get it out...If so can someone help me with a good descripton of how to ?
 It looks like the knob panel removes then the front door panel and I can get at everything but I dont know the proper way to remove ether.
Thanks agan guys I appreciate all the help

[tgoods]

This job is done from the front.  There are two screws on the bottom of the console about one inch from the ends.  They are attached to a spring loaded clip.  Just pull them down with pliers and the console will flip down.  Remove the ground wire and the two 5/16 screws from the front panel.  Push the front panel up to remove it from the clips. Remove the belt. Remove the top panel so you can spread the sides apart and remove the drum. 

[cvcman]

great, I dropped the panel down to see how it was done, pc of cake, looks like a pretty easy job right ? The wheels look the hardest...Anything else I should do whle in there besides vaccum ?

Thanks so much

[tgoods]

Check the belt, if the rubber is cracked, replace it.  The idler pulley should spin freely. 

3394652

691366

[cvcman]

belt looks good roller turns free...even the rollers that you said to replace seem fine but you think I should replace them anyway I have a new set here....

[tgoods]

It's hard to say without looking at it.  If the rubber on the rollers have worn down enough, it will create a gap at the bottom of the drum that the clothes can get caught in.

[cvcman]

ill chg them

[cvcman]

How long do I need to let the adhesive dry

[tgoods]

It dries fast.  You can install the drum almost immediately after installing the seal.