Kenmore 110.088732791 stackable - access to the control panel?

[kcincolo]

Good day -

I have a 110.088732791 Kenmore stackable, and the washer is overfilling.  Actuating the cycle control shuts off the water flow, so I believe the solenoids are fine.  I suspect the pressure switch or hose.  I have been unable to figure out how to remove the control panel from underneath the dryer unit without removing one side panel.  Any hints?

Thanks in advance for any response.

KC 

[Bailey]

Take the two screws out that hold the angled panel in place. Then look for two screws [one on each side] that go in from the bottom of the control panel.
Like this   [ O o o     o O ]  This is supposed to look like the control panel with knobs.
                1                1
                                  ^
  These are the screws.   


 Hey I never claimed to have any artistic talent. Hope this helps.

[tgoods]

Those screws are attached to a spring loaded clip.  I never unscrew them, I just pull them straight down with pliers or visegrips.  Then the console flips down.  That's the easy part.  Sometimes it's a pain to put back together.

[kcincolo]

Thanks - those pins are the ticket - I fiddled with those for a while before posting, trying to figure out how to open the dang thing.   Problem was the tube - abraded where it entered the bottom of the dryer cavity.

Best to all.....

klc

[tgoods]